MENU FUNCTIONS > 153NETWORK MENUThis menu controls the operation of the printer’s 10Base-T/100Base-TX network interface.NETWORK MENUItem Settings ExplanationTCP/IP ENABLE / DISABLE Enables or disables this network protocol.NETBEUI ENABLE / DISABLE Enables or disables this network protocol.NETWARE ENABLE / DISABLE Enables or disables this network protocol.ETHERTALK ENABLE / DISABLE Enables or disables this network protocol.FRAME TYPE AUTO / 802.2 /802.3 / ETHERNETII / SNAPSelects the Ethernet MAC layer frame type.IP ADDRESS SET AUTO / MANUAL Specifies whether IP address allocation isautomatic (DHCP) or manually assigned.IP ADDRESS xxx.xxx.xxx.xxx Current assigned IP address. To change,press ENTER and use +/– keys to increment1st octet, then press ENTER again to moveon to next octet. When 4th octet has beenset, press ENTER again to register newaddress.SUBNET MASK xxx.xxx.xxx.xxx Current assigned subnet mask. To change,proceed as above.GATEWAY ADDRESS xxx.xxx.xxx.xxx Current assigned gateway address. Tochange, proceed as above.INITIALIZE NIC? EXECUTE Initialises the network hardware.WEB/IPP ENABLE / DISABLE Enables or disables Web config. facility andInternet Printing Protocol.TELNET ENABLE / DISABLE Enables or disables Telnet config. facility.FTP ENABLE / DISABLE Enables or disables communication via FTP.SNMP ENABLE / DISABLE Enables or disables SNMP protocol.LAN NORMAL / SMALL Selects network size.HUB LINK SETTING AUTO NEGOTIATE100BASE-TX FULL100BASE-TX HALF10BASE-T FULL10BASE-T HALFSets full or half duplex for communicationvia a network hub.
