Configuring your machine.... > 55System configuration menuITEM CHOICE DESCRIPTIONPow Save Time 5153060240Adjusts the idling time before theprinter automatically switches intopower saving mode. In this modepower consumption is reduced to a lowlevel required to just keep the printeroperating and ready to receive data.When a job is sent the MFP will requirea warm-up time of up to 1 minutebefore printing can begin.Personality AUTOEMULATIONPCLIBM PPR III XLEPSON FXPS3EMULATIONThis item selects which industrystandard emulation your MFP shoulduse. When set to AUTO, incoming datais examined and the correct emulationis automatically selected each time aprint job is received.USB PS Protocol RAWASCIISelects PostScript data format for USBport.Clrable Warning ONLINEJOBWhen ONLINE, non-critical warnings,such as requests for a different papersize, can be cleared by pressing the ONLINE button. When set to JOB, they arecleared when the print job resumes.Auto Continue ON/OFF Determines whether or not the MFP willautomatically recover from a memoryoverflow condition.Manual Timeout OFF30 sec60 secSpecifies how many seconds the MFPwill wait for paper to be fed beforecancelling the job.Wait Timeout 5~40~300OFFSpecifies how many seconds the MFPwill wait when received data pausesbefore forcing a page eject. InPostScript Emulation mode the job willbe cancelled if timeout occurs.Low Toner CONTINUESTOPSpecifies whether the MFP shouldcontinue printing even after a low tonercondition is detected.Jam Recovery ON/OFF Specifies whether the MFP shouldperform jam recovery after a paper jamhas occurred. If ON, the MFP willattempt to print again any pages lostdue to a paper jam once the jam hasbeen cleared.
