4.PRINTING FROM UNIX/LinuxPrinting From Application 1774 PRINTING FROM UNIX/Linux Page LayoutThe booklet mode page layout can be selected using the following options.If left2right=off then long edge binding is selected, otherwise if left2right=on then short edge binding is used.Example: The command to select left to right page layout for the booklet printing mode is “lp -o left2right=on ”. Center MarginThe booklet mode center margin can be selected using the following options.Example: The command to select the center margin value for the booklet printing mode is “lp -o centermargin=value”. Outer MarginThe booklet mode outer margin can be selected using the following options.Example: The command to select the outer margin value for the booklet printing mode is “lp -o outermargin=value”.Option Value Alternate Value Descriptionleft2right=off OFF Select right to left page layout for the booklet printingmode.This value decides the layout of the pages in thebooklet.If this value is OFF then the layout of pages is Right toLeft as shown in the figure below.left2right=on ON Select left to right page layout for the booklet printingmode.This is the default setting.If the value is ON then the layout of the pages is fromLeft to Right as shown in the figure below.Option Value Alternate Value Descriptioncentermargin=valueSelect the center margin value for the booklet printingmode.This value specifies in pixels the Center Margin or the“Gutter”. This is in addition to the center margin alreadyspecified by the application. The valid range for value is0 - 300. Default is 0.Option Value Alternate Value Descriptionoutermargin=valueSelect the outer margin value for the booklet printingmode.This value specifies in pixels the Outer Margin or the“Creep” per page, which should take place whileprinting a booklet. The valid range for value is 0 - 600.Default is 0.
