45584901TH Rev.1 10-1 /Oki Data CONFIDENTIAL10. eXTeRNaL COUNTeRs10.1 OutlineThis chapter describes the interface between the equipment and coin controller. This equipmentdoes not support card controller and mechanical counter.10.2 SignalNotes:• Use 24V supplied from the main equipment as power for the output signals (CTRON) fromthe transistor.• Do not connect inductive loads, such as a mechanical counter or a relay coil.10.2.1 Pin Layout1. Connector on the PU board: COIN (JST-made B20B-CZHK-B-1(LF)(SN)(V)) (Coin Controller)PinNo. I/O Signal name Function Voltage level Remarks GQ-12601 GND SG Signal Ground 0V -2 In CTRCNT Copy permissionSignal 1L=0V, H=DC3.3V -3 Power +24V 24V line DC24V+10%,-5%-4 Out KCTRON MechanicalCounter On SignalOpen Collector L: ON -5 Power +24V 24V line DC24V+10%,-5%-6 Out CTRON Total Counter OnSignalOpen Collector L: ON In use7 In CTRCNT Copy permissionSignal 1L=0V, H=DC3.3V L: Allowed In use8 Out MCRUN Ready to CopySignalOpen Collector L: Operating In use9 Out EXTCTR Exit Sensor OnSignalOpen Collector L: Operating In use10 GND PG Power ground 0V In use11 Out BKCTR Black modeCounter SignalOpen Collector L: Operating -12 Out MNCTR Mono color modeCounter SignalOpen Collector L: Operating -13 Out FLCTR Full color modeCounter On SignalOpen Collector L: Operating -14 GND SG Signal Ground 0V -15 Out SIZE3 Paper size Signal 3 Open Collector L: Operating -16 Out SIZE2 Paper size Signal 2 Open Collector L: Operating -17 Out SIZE1 Paper size Signal 1 Open Collector L: Operating -18 Out SIZE0 Paper size Signal 0 Open Collector L: Operating -19 Power +5V (Sleep) 5V line DC5.1V At the sleepmode: OFFIn use20 - N.C. - - -
