45584901TH Rev.1 5-1 /Oki Data CONFIDENTIAL5. eRROR CODe aND TROUBLesHOOTING5.1 General DescriptionsThis chapter explains the procedures for solving troubles occurring in the equipment.When a trouble occurs, check if an error code is displayed on the LCD screen of the controlpanel first. If displayed, refer to“ P. 5-4 “5.2 Error Code List”” to figure out the classification andcontents of the error, and then refer to “ P. 5-27 “5.3 Diagnosis and Prescription for Each ErrorCode”” to remove its cause.If not displayed and the equipment does not operate properly or images are not printed properly,refer to “ P. 5-98 “5.4 Other errors”” to remove its cause.Note:If unusual odor is detected or if smoke or fire comes out of the equipment, immediately turnthe power OFF.Even in the cases other than the above, fully observe safety precautions.If any PC board or HDD shall be replaced, refer to“6.3Precautions for Installation of GP-1070and Disposal of HDD/Board”.5.1.1 If a problem continues even after performing all troubleshooting.If a problem continues even after performing all troubleshooting and technical tips, report theproblem to the appropriate service center along with the following information. This informationwill help the service center understand your problem and take quick action to find the solution.1. Serial Number2. List PrintRefer to the appropriate Service Manual / Service Handbook for the detailed procedure toobtain a List Print.A. Enter the value given below to obtain a List Print by CSV file.9S-300: All CSV filesB. Enter the value given below to obtain a List Print by printing it out.9S-101: 05 code9S-102: 08 code9S-106: Error history (1000 cases max)9S-108: Firmware update log (200 cases max)9S-110: Power on/off log (100 cases max)3. For image-related problems, collect image samples with the problem areas and the feedingdirection marked first. Then provide information about the media type and weight, and theprint data / spool files for duplicating the problem.4. For abnormal acoustic noise, describe the situation in as much detail as possible.5. For hardware-related problems, provide photos of any broken parts, paper jams, etc.In case of paper jams, include the type of paper and its manufacturer.6. For software-related problems, provide list prints, Web Page Logs and the detailed procedureneeded to duplicate the problem.* This is the minimum information required to report a complaint. It would be appreciated ifyou could obtain additional information.* Follow the directions of the service center if they request additional information as eachissue is unique to some degree.
