Oki MICROLINE ML380 Maintenance Manual

Also see for ML380: User guide Handbook Parts Breakdown

40959201TX Rev.1 67 /(f) Additional details:• Top of form will be set.• The value of the skip over perforation will be cleared when the valid n data isreceived.• Bit 7 is cleared and set to that value in Epson mode.• In Epson mode if the line spacing is set to 0 this command is ignored.22) Set perforation auto skip(a) Code: ESC N n(b) Compatibility: EPSON LQ/IBM(c) Function:Upon receipt of this command the printer sets the skip over perforation to n lines.(d) Range:Range n = 1 to 127 (Epson) Number of lines to skip.n = 1 to 255 (IBM)(e) Out of range:• If n is equal to or greater than the current form length, in lines, this command willbe:— Set to form length (Epson mode).— Ignored (IBM mode).• If n = 0 (or n > 127 in Epson mode), the last value will remain set.(f) Additional details:• Skip over perforation value will not be changed by the line pitch change.• Entering to the area of skip over perforation by LF, VT, CR (with LF), ESC J nand auto line feed will cause the skip over perforation and feed to the top of form.(g) Related functions:• Line spacing value is based on ESC 0, ESC 2, ESC A n, ESC [ n or ESC 3 n.• ESC O resets skip over perforation..23) Reset perforation auto skip(a) Code: ESC 0(b) Compatibility: EPSON LQ/IBM(c) Function:Upon receipt of this code the printer resets the skip-over-perforation value to thedefault value.(d) Additional details:• Skip over perforation is set to default when power-down, power-up or l-Prime (orESC @ in Epson mode) occurs.• Skip over perforation is cleared when the form length is changed by the followingcodes:ESC C n and ESC C NUL n.