Chapter 6 - Customising812. Enter speed access No. 05 and wait.3. Enter the 4-digit numeric password using numeric keypad, pressENTER.4. If there is no current password registered, this password will now beregistered and the machine will return to standby mode.5. If there was a password registered previously and you have enteredit correctly, the display will prompt you to close the password. PressENTER to confirm password cancellation, then press MENU/EXITto return to standby mode. If numbers do not match, the display willindicate an invalid password.Restricted access ID (Department Code)This is a 4-digit numeric password that is must be input to gain access tomachine operations when the machine is set in the Restrict Access mode.Up to 24 RESTRICTION ID passwords can be registered at one time.Speed access No. 06.Note: Speed access code 19 Department Code must be set to ON forRestrict Access ID (Department Code) to function .Setting restricted access ID1. Press MENU/EXIT to enter the menu.2. Enter speed access No. 06 and wait.3. Enter the department number (1-24), press ENTER.4. Enter the 4-digit password (0000 to 9999) using the numeric key-pad, press ENTER.5. If the number is already registered, the display will confirm that italready exists.6. Enter another 4-digit ID number, press ENTER.7. Repeat steps 3 to 6 until all desired ID numbers have been regis-tered.8. Press MENU/EXIT to return to standby mode.Cancelling restricted access ID1. Press MENU/EXIT to enter the menu.2. Enter speed access No. 06, wait.
