Section 5 COPY FUNCTIONS5-6Standard Margin[Inch specifications]The position of the image of the original is shifted for copying and a0.13/0.25/0.38/0.50/0.63/0.75 (") (1/8-inch increments) widthbinding margin created.[Metric specifications]The position of the image of the original is shifted for copying and a1 to 18 mm (1 mm increments) width binding margin created.NoteIf the left width of the Binding Margin is set whensetting the 2-Sided Copy, the right side of the BindingMargin will be set automatically for the reverse side bythe 2-sided copy rotational setting in the case where it isrotated.1 Set the original.IMPORTANT!Place the original so that the side to be set for the Marginshift is on the right side (on the left side, in the case ofthe optional Document Processor) and check its positionafter setting it. If the original is placed in the wrongdirection, the Binding Margin will not be produced in theposition set.NoteThe Binding Margin can also be set in the DefaultSettings Mode. (Refer to P.6-25 "Margin Shift".)The value set in the Default Setting Mode will inherit thevalue that is set at the time when the copy is made.2 Press the [Margin] key.The Margin Shift display will light up.3 Press the [Start] key.The copier will begin copying.Setting the MarginUse the procedure given below to change the Margin.1 Press the [Margin] key for 3 seconds. The Default SettingsMode for the Margin will be displayed.Making a margin space on the copiesOriginal Copy
