Olivetti d-Copia 16 Operation Manual

Contents

Olivetti d-Copia 16 Operation Manual Manual pdf 96 page image

Section 8 TROUBLESHOOTING8-2“E91” appears on the copy quantity display. Copies cannot be produced because memory is full during the interruptcopy operation. Interrupt Copying cannot be carried out so press the[Stop/Clear] key and then press the [Interrupt] key again after the dataread in has been deleted to exit the Interrupt Copying.After the copying operation for the interrupted copy has been completed,repeat the procedure again.“OP” appears on the copy quantity display. The front cover of the copier is open. Close the front cover. –“OP1” appears on the copy quantity display. The left cover of the Document Processor is open. Close the left cover. Closethe front cover.–“OP2” appears on the copy quantity display. The left cover of the copier is open. Close the left cover.“OP3” – “OP5” appears on the copy quantitydisplay.The left cover of the optional drawer is open. Close each of the left covers. –“C” and a number are alternately displayed onthe copy quantity display.Make a note of the C and the number. Turn the power switch OFF, unplugthe power cord and contact your service representative.–“A” and a number are alternately displayed inthe copy quantity display. (except A-3200)Turn the power switch OFF/ON. Usage will be possible again once theregular display returns. When A and the number are again displayed onthe copy quantity display, make a note of the A and the number. Turn thepower switch OFF, unplug the power cord and contact your servicerepresentative.–“A3” and “200” are displayed alternately in thecopy quantity display.Condensation is occurring within the copier. Turn the Power Switch OFFand then turn it ON again after 10 to 20 minutes have elapsed.–The Paper Misfeed display blinks on and off and“JXX” appears on the copy quantity display.XX indicates the paper misfeed locationnumerically.A paper misfeed has occurred. Remove the jammed paper. 8-3“OF” appears on the copy quantity display. 250 copies have been stored in the storage section. Remove the paper, pressthe [Start] key and resume copying.–The Periodic Maintenance indicator blinks onand off.This is a notification that the time for periodic maintenance is approaching. –The Periodic Maintenance indicator lights up. It is time for Periodic Maintenance. Contact your service representative. –The Paper Supply indicator lights up and “PE”appears on the copy quantity display.There is no paper in the drawer level that corresponds to the lightingindicator. Replenish the paper and set the drawer.3-1“PF” appears on the copy quantity display. Check the Multi-bypass Tray paper. Set paper in the Multi-bypass Tray inthe event there is no paper present there. When the Multi-bypass Traypaper fails to be fed, reset the paper.3-4“U1 appears on the copy quantity display. Check the key counter or key card and make sure it is set properly. 7-4“= = =” appears on the copy quantity display. Department Management being set. Use the Keypad to enter the assignedSection Code to perform copying operations. Press the [Management] keyafter copying is finished to display “= = =” again.6-6“-” appears on the copy quantity display. The copier is in the Off mode setting. Press the [Energy Saver] key to exitthe mode.4-8“---” appears on the copy quantity display. The copier is in the Low Power mode setting. Press any key to exit themode or in the case where the optional Document Processor is installed, setan original in the Document Processor.4-7Display Corrective Procedure ReferencePage