Omnia ONE Installation And Operation Manual

Also see for ONE: Installation and operation manual Installation and operation manual

Contents

Omnia ONE Installation And Operation Manual Manual pdf 49 page image

30More information on each of these processing stages can be found below in the descriptions for each processingparameter control.Increasing any setting will lead to more aggressive processing. For example, a higher drive setting adds more gaininto the dynamics section, a higher attack or release setting means a faster time constant, a higher gate thresholdsetting means more gating will occur, and a higher (farther to the right on the control) setting for a filter means morefiltering is occurring (so the lowest frequency settings for a low pass filter are farthest to the right on the control).Depending on the type of control adjusted and its range, the changes you make can affect the sound in subtle orextreme ways. Our advice is to make a limited number of changes at a time, make those changes in smallincrements, and then listen to the results for a period of time before making any further adjustments. Keep in mindthat should you get “lost” you can always go back to where you started by simply recalling the factory preset thatyou started with. The factory presets cannot be overwritten.PresetOmnia.ONE is equipped with a selection of factory presets that can be used to instantly configure the processing forcommon applications. The currently loaded preset is displayed to the right of Preset: on the top line of the MainMenu.Highlighting Preset: and clicking the jog wheel (see Using the Jog Wheel on Page 10) will open the Preset menu.Rotating the jog wheel will scroll through all of the factory presets as well as any user presets that have been storedwithin the unit’s non-volatile memory. The currently loaded preset will appear with square brackets around it.Clicking the jog wheel will load the displayed preset into the Omnia.ONE, instantly setting the various processingparameters.To exit the Preset menu without loading a preset, rotate the jog wheel clockwise until *cancel* is displayed andclick.By alternately loading different presets you may compare the sound between them.Here in the Preset: menu, you may select and load presets to use, but not save, delete, or rename them. Thoseoperations may be accomplished from within the Processing menu.ProcessingHighlighting and clicking Processing from the main menu opens up the Processing menu that contains theseoptions: Adjust Processing, Save Preset, Delete Preset, Rename Preset and <-Exit. This is where the sound of theOmnia.ONE can be fine-tuned and customized. Once customized, this is also where your user presets are saved,deleted and renamed. Each submenu in the Adjust Processing menu can be highlighted, clicked to open, and theindividual controls within can be adjusted to individual taste.Since you cannot build a preset from scratch, a factory preset must be used as a starting point for creating your“signature sound.” Each processor parameter may be adjusted to taste as required. Once the processing is adjusted,the Save Preset function is used to store your changes as a new user preset to non-volatile internal memory. Thefactory presets cannot be overwritten.Using the Delete Preset and Rename Preset options, existing user presets may be deleted from memory or renamedas needed. The original factory presets can never be deleted or renamed.We will discuss the Save Preset, Delete Preset, Rename Preset and <-Exit options first before delving into thedetails of the Adjust Processing menu.