Omnia ONE Installation And Operation Manual

Also see for ONE: Installation and operation manual Installation and operation manual

Contents

Omnia ONE Installation And Operation Manual Manual pdf 59 page image

40baseband signal up to 53kHz, except for the 19kHz pilot. No matter how hard you drivethe composite clipper, you cannot clip the stereo pilot. Embedded within the compositeclipper is a 53Khz phase linear low pass filter for SCA protection. This filter removesclipping harmonics and prevents them from affecting the SCA and RDS region.<-ExitClick on this option to return to the Adjust Processing submenu.Input/OutputThis submenu provides level adjustments for the audio inputs and the absolute peak operating level of the AnalogXLR, Composite MPX (FM Style Only), AES-3 (AES/EBU) and Livewire outputs. Choices governing the selectionof the input audio source (Analog, AES Digital or Livewire) and signal mode (Stereo or Mono) are also found here.There is also a setting to disable Livewire if needed.These I/O settings are generally “set once and forget” parameters, usually adjusted during initial installation andthen left alone. These I/O settings are not saved with a processing preset but can be saved, loaded, deleted orrenamed as “I/O Configurations” using options available in this submenu.Mtr Select (Meter Select)Selects whether the Input levels, Analog Out (analog output) levels, AES Out (AES/EBUoutput) levels or LW Out (Livewire output) levels are displayed on the front panel L & R (Left &Right channel) LED bargraph meters.InputThere are eleven controls under the heading “Input” and each will be explained in the order inwhich they appear in the menu:<-ExitClick on this option to return to the Input/Output menu.Input Src (Input Source)Allows the selection of Analog, AES/EBU (digital) or Livewire as the primary inputsource to the Omnia.ONE.Fover Time (Failover Time)Failover Time is a feature that when set to a value other than zero (disabled) allows theOmnia.ONE to automatically select another input source if the currently selected onefails. Failover Time is the amount of time that will elapse after the failure of audio on theprimary input source before the unit makes the decision to switch to the secondary(failover) input source. For instance, if Failover Time is set for 5 seconds and the primaryaudio source fails, 5 seconds later the unit will switch to the secondary audio input if thatinput is active. If, at any time, audio is restored on the primary input (for 1 second,continuously), the unit will switch back to the primary audio input. It will remain withthe primary input unless another failure is detected.Fover Src (Failover Source)Failover Source selects which audio input: Analog, AES/EBU (digital) or Livewire willserve as the secondary audio input. Note that the audio input that is selected under Input