Panasonic AG-CPD15P Operating Instructions Manual

Also see for AG-CPD15P: Operating instructions

Contents

Panasonic AG-CPD15P Operating Instructions Manual Manual pdf 81 page image

81Administrator Operations on theRemote Control Panel (separately sold)Zoom LimitUse this function to enter maximumzoom ratio.Setting : ×22, ×220AGC LevelUse this function to set the level ofcamera input gain control.Setting : LOW, MID, HIGH, OFFInit BacklightUse this function to turn backlightcompensation on or off when thepower is on.Setting : ON, OFF, LAST∗Init AE ShiftU s e t h i s f u n c t i o n t o a d j u s tbrightness when the power is on.Setting : -2, -1, 0, +1, +2, LAST∗FlipUse this function to determinewhether to vertically flip cameravideo image or not.Setting : ON, OFFAutoZoom MagnificationUse this function to set the targetzoom-in ratio.Setting : ×1, ×2, ×3, ×4, ×5, ×7, ×10,×15, ×22AutoZoom TimeUse this function to set the zoom-inpause time.Setting (sec.) : 3, 5, 8Init Camera LEDUse this function to turn the cameralamp on or off when the power is on.Setting : ON, OFF, LAST∗CameraAdministrator Setup (continued)∗ Applies the setting in effect when power was last turned off. Unless power isturned off properly, the operating state may not be saved correctly.TriggerUse this function to turn triggerdisplay on or off upon trigger signal(GPIO1–8) inputs.Setting : ON, OFFNote:The Detailed On-Screen Display (see“Viewing the status of this unit” onpages 60, 69) will hide this indication.TimeUse this function to turn date and timedisplay on or off during recording.Setting : ON, OFFNote:The Detailed On-Screen Display (see“Viewing the status of this unit” onpages 60, 69) will hide this indication.Display for the vehicleidentification and name of alocation (Source@Area)Use this function to turn vehicleidentification and name of a locationon or off during recording.T h i s i n f o r m a t i o n a p p e a r s a s“Source@Area”.Source : The first 5 characters in thevehicle identificationArea : The first 4 characters in thename of a locationNotes:• If the Source is less than 5 characters,the number of characters for the Areais adjusted so that the total number ofcharacters becomes 10.• If the Area is less than 4 characters,the number of characters for theSource is adjusted so that the totalnumber of characters becomes 10.• “@Area” is displayed when thereis no Source.• The vehicle identification only isdisplayed when there is no Area.