Panasonic AG-MX70 Operating Instructions Manual

Also see for AGMX70 - AV SWITCHER: Brochure & specs

Contents

101Installation of the AG-VE70The AG-VE70 is a 3D effect board that enables the 3D patterns, etc. of the AG-MX70 to be used.Follow the procedure below to install it.Always consult your dealer or authorized service center regarding installation of the AG-VE70 in the AG-MX70.Specifications[AG-VE70](3D effect board: optional accessory)[AG-YA70](SDI interface board: optional accessory)Power Source: DC 5 V, 3.3 VPower Consumption: 6.3 Windicates safety information.Operating temperature: 41 °F to 104 °F(+ 5 °C to + 40 °C)Operating humidity: Less than 80%Standard: SMPTE-259M-C standardcomplied withPower Source: DC 5 V, 3.3 VPower Consumption: 6.1 Windicates safety information.Operating temperature: 41 °F to 104 °F(+ 5 °C to + 40 °C)Operating humidity: Less than 80%1) Turn off the power of the AG-MX70, remove the tenscrews from the bottom panel, and detach the toppart including the LCD. Refrain from using any forceto pull the top part away from the bottom part sincethe two parts are still connected by cables.2) Remove the 20 screws, and remove the shield plate.3) Refer to the figure on the left, and insert the AG-VE70.4) Remove the five screws provided on the fivehexagonal posts in the center of the motherboard.(Refer to the figure on page 100.)5) In the same way, plug the cable attached to the AG-VE70 into the AG-MX70. Route the wires whilecarefully ensuring that they do not make contact withthe transition lever unit.6) Secure the five screws which were removed in step4).7) Secure the screws which were removed in steps 2)and 1).Screws (a 10)3)5)

/ 102

Related manuals for Panasonic AGMX70 - AV SWITCHER