79Before useOperation confirmationThis completes installation of all of the software. Use thefollowing procedure to confirm that the software has beeninstalled correctly.1) Confirm that the PC and the AG-MX70 have beenconnected correctly and that the power of the AG-MX70 is switched on.2) Select “Programs” > “Panasonic AG-MX70” > “MX-Navi” from the Windows Start menu. MX-Navi willstart.3) When the display column of the status bar on the leftbottom of the main window of MX-Navi shows“Connecting,” it means that the software has beeninstalled correctly.5) The installation contents confirmation screenappears.To proceed with the installation of the contentsshown, click the “Next” button. To change thecontents, use the “Back” button to return to theprevious screen, and change the settings.Check that this columnshows “Connecting.”If “Not connecting” is shown, check the following.≥ PC and AG-MX70 must be connected correctly.≥ The power of the AG-MX70 must be switched on.≥ The length of the USB cable must be within 3 m.When a USB hub is being used, correct operation may beobtained when the hub is removed and the cable isconnected directly to the USB port of the PC.Installation of MX-NaviAfter installing the USB driver, install MX-Navi, the softwarefor handling image exchange with the AG-MX70. Follow thesteps below.1) Select “Run…” from the “Start” menu. Click the“Browse” button, select Setup.exe in the MX-Navifolder of the setup CD-ROM, and click “OK.”2) The setup start screen will be displayed. Click the“Next” button.3) The screen for setting the MX-Navi installationdestination will be displayed. If the destination shownis the one desired, just click the “Next” button.To change the installation destination, click the“Browse” button, change the installation destination,and click the “Next” button.4) The screen for selecting the installation type isdisplayed. When “Typical” has been selected, theprogram files of MX-Navi and sample images areinstalled. When “compact” has been selected, onlythe MX-Navi program is installed.Select the type and click the “Next” button.6) After the files have been copied, the installation endscreen appears. Installation is completed by clickingthe “Finish” button now.