43Setup (Initial Settings)How to protect the menusSet the MENU switch to the SET position.The unit is now set to the menu setting mode,and the menu screen appears on the videomonitor.1Opening the setup menus can be prevented evenwhen the MENU switch on the front panel is set to theSET position by setting the unit to the menu protectmode.Press the RESET button.The unit is set to the default setting mode, andthe default setting screen appears on the videomonitor.23SELECT MODE0 ESCAPE1 LOAD2 SAVE3 PROTECTMENU PROTECT OK?NOYESPress the MENU-UP button or MENU-DOWNbutton to move the cursor to the YESposition, and press the SET button.The menu screen is now displayed.4Press the MENU-UP button or MENU-DOWNbutton to move the cursor to the PROTECTposition, and press the SET button.The unit is set to the menu protect setting mode,and a screen for verifying whether to protect thesetup menus appears on the video monitor.Set the MENU switch to the OFF position.The unit is set to the menu protect mode.Now, even if the MENU switch is set to the SETposition, the menu setting mode will not beestablished, and “MENU PROTECTED” willappear on the video monitor screen.If, during the menu protect mode setting, theMENU switch is set to the SET position whileholding down the METER button on the frontpanel, the menu setting mode will be establishedand the regular menu settings can be performed.Perform steps 2 through 7 of “Setting methodusing on-screen menus.”(See page 40)5Press the MENU-UP button or MENU-DOWNbutton to move the cursor to the NO position,and press the SET button.The menu protection is now released.3How to release the menuprotectionSet the MENU switch to the SET positionwhile holding down the METER button on thefront panel.The unit is set to the menu setting mode, and themenu screen appears on the video monitor.12MENU PROTECT OK?NOYESPerform steps 2 and 3 of “How to protect themenus” above.The screen for verifying whether to protect thesetup menus appears on the video monitor.