Panasonic AJ-SPD850E Operating Instructions Manual

Also see for AJ-SPD850E: Parts list Operating instructions

Panasonic AJ-SPD850E Operating Instructions Manual Manual pdf 43 page image

43Setup menus (continued)SYSTEM menuNo./Item Description11SYS SC COAR.Coarse adjustment of system phase: 90 ° unitsNote:If setting operation isperformed, the settingvalue does not return tofactory (default) setting.0000 00001 900002 1800003 27012SYS SC FINEFine adjustment of system phase:Variable range ±45 ° or more–: Advanced, +: DelayedNote:If setting operation isperformed, the settingvalue does not return tofactory (default) setting.0000 –128: :0128 0: :0255 12713SYS HSystem phase adjustment: 74 ns steps–: Advanced, +: DelayedNote:If setting operation isperformed, the settingvalue does not return tofactory (default) setting.0000 –128: :0128 0: :0216 127No./Item Description14SCH COARSESCH phase adjustment: 90 ° units(The SC phase changes but the H phase does not change.)–: Advanced, +: Delayed0000 00001 900002 1800003 27015SCH FINESCH phase adjustment:Total variable range: ±45 ° or more(The SC phase changes but the H phasedoes not change.)–: Advanced, +: Delayed0000 –32: :0032 0: :0064 3216AV PHASEThis adjusts the audio output phasewith respect to the video output:20.8 μs steps–: The audio output phase is advancedwith respect to the video output.+: The audio output phase is delayedwith respect to the video output.0000 –100: :0100 0: :0200 100The underlined items indicates the initial setting.18SYS H OFFSETSystem phase adjustment.0000 –3 : –13.4 μsec0001 –2 : –8.96 μsec0002 –1 : –4.52 μsec0003 0 : 0 sec0004 1 : +4.52 μsec0005 2 : +8.96 μsec0006 3 : +13.4 μsecNote:If setting operation is performed, thesetting value does not return to factory(default) setting.19SYS SC/HThis sets whether the system phase isto be adjusted by the memory cardrecorder or from the external encoderremote controller.0000 REMOTE :The system phase is adjusted fromthe external encoder remotecontroller.0001 LOCAL :The system phase is adjusted by thememory card recorder.Note:This setting does not take effect whenLOCAL has been selected by the ENCCONTROL switch on the front panel.Video output signal adjustmentsThe video output signal adjustments are made by using the ENC CONTROL switch on the front panel and selecting theSYSTEM menu item No. 19 (SYS SC/H) settings. A control matrix of the adjustments is shown below.ENC CONTROLLOCALREMOTESYSTEM menu item19: SYS SC/HLOCALREMOTELOCALREMOTESYSTEM menu item11: SYS SC COAR.12: SYS SC FINE13: SYS HThe memory card recorderThe memory card recorderExternal encoder remote controllerFront panel (under section)VIDEO LEVELCHROMA LEVELSET UP/BLACKHUE/CHROMA PHASEThe memory card recorderExternal encoder remote controllerSetting Item adjusted