51Setup menus (continued)No./Item DescriptionUSER menu 303STD/NON-STDThis selects STD or NON-STD inaccordance with the composite inputsignal.0000 AUTO :Standard/non-standard signals areautomatically identified andprocessed.0001 STD :Standard signals are processed.(Forced STD)0002 N-STD :Non-standard signals are processed.(Forced NON-STD)Notes:• Use the non-standard (NON-STD)setting when video or audio troubleoccurs with signals from laser discs or asatellite.• At the NON-STD setting, the imagesshown on the front panel's LCD monitorwill be significantly disrupted when theunit's operation is transferred from theplay mode to EE mode: this is normaland not indicative of malfunctioning.304REF LOCKThis selects the REF LOCK mode.0000 AUTO :Servo is synchronized with the inputsignal during recording, or with theREF signal during playback.0001 EXT :Servo is synchronized at all times withthe REF signal.0002 AUTO1 :Servo is synchronized with the inputsignal during recording, or with theREF signal during playback.When there is no reference (REF)signal, the EE output is synchronizedwith the internal reference signal atthe AUTO setting or with the STDinput signal at the AUTO1 setting.The AUTO1 setting is selected whenthe STD signal is to be used.Note:At the AUTO setting, the images shownon the front panel's LCD monitor will besignificantly disrupted when the unit'soperation is transferred from the playmode to EE mode: this is normal and notindicative of malfunctioning.315AFTERCUE-UPThis selects the mode after cue-upoperation is complete.0000 STOP : STOP mode0001 STILL : SHTL STILL mode320VAR FWD MAXThis sets the maximum SLOW FWDspeed.0000 +4 : +4x speed0001 +2 : +2x speed0002 +1 : +1x speedNote:At any speed setting other than 0 (+4),the phase cannot be synchronized fromthe editing controller.321VAR REV MAXThis sets the maximum SLOW REVspeed.0000 –4 : –4x speed0001 –2 : –2x speed0002 –1 : –1x speedNo./Item Description323JOG FWD MAXThis sets the maximum JOG FWDspeed.0000 +4 : +4x speed0001 +2 : +2x speed0002 +1 : +1x speedNotes:• The maximum speed is set to +1 xwhen the dial on the front panel isoperated.• At any speed setting other than 0 (+4),the phase cannot be synchronized froman editing controller which synchronizesthe phase using the JOG command.324JOG REV MAXThis sets the maximum JOG REVspeed.0000 –4 : –4x speed0001 –2 : –2x speed0002 –1 : –1x speedNote:The maximum speed is set to –1 x whenthe dial on the front panel is operated.The underlined items indicates the initial setting.
