Output 5/6 screenOutput 5/6OSD Off With R-Tally OffOSD Status OffTally EnableTally Brightness LowStatus Lamp EnableExternal OutputOutput1 OffOutput2 OffReturnOSD Off With R‑Tally [Off, On]Off or on the function that turns off camera menu, status, and otherdisplays when red tally signals are received via commands orcontacts.When the red tally signal releases, the camera menu display willreturn.OSD Status [Off, On]Turn the status display during AWB and ABB off/on, or error displaywhen an error occurs.Tally[Enable, Disable][Disable] or [Enable] is set here for the function which turns on orturns off the tally lamp using the tally control signal.Tally Brightness [Low, Mid, High]Adjust the brightness of the tally LED.Status Lamp[Enable, Disable][Disable] or [Enable] is set here for the status display lamp.When you want the status display lamp to stay off while this unit is inoperation, set to [Disable].• Even when set to [Disable], the status display lamp may lightup when this unit is starting up, updating firmware, or trouble isoccurring.External OutputSelect the signal type output from the External Output signal lines(Output1, Output2) of the RS‑422 connector. (→ page 16)Output1 [Off, R‑Tally, G‑Tally]Output2 [Off, R‑Tally, G‑Tally]Off Signal is not output.R-Tally The reception status of the red tally signal is output.G-Tally The reception status of the green tally signal is output.ReturnReturn to the previous menu level.Output 6/6 screenOutput 6/6UHD Crop Off3G SDI Out CropIP Out CropCrop Out YLCrop Marker YL+G+MGCrop Adjust YLCrop H Position 960Crop V Position 540ReturnUHD Crop [Off, On]Switch off/on the crop function which crops UHD (3840 × 2160)images to FHD (1920 × 1080) images.This is enabled only when [Format] in [System] screen is thefollowing.2160/59.94p, 2160/29.97p2160/50p, 2160/25p2160/24p, 2160/23.98p• When [UHD Crop] is changed, IP video transmission is temporarilystopped.• [H.264(UHD)], [H.265(UHD)], and [JPEG(UHD)] cannot be selectedin [Streaming mode] when [UHD Crop] is [On]. (→ page 93)When [H.264(UHD)], [H.265(UHD)], or [JPEG(UHD)] is selected in[Streaming mode] and [UHD Crop] is switched from [Off] to [On], the[Streaming mode] setting changes to [H.264].3G SDI Out [Full, Crop]IP Out [Full, Crop]Make the settings for Full/Crop for images output to the 3G SDI OUTconnector and IP.Full FHD down-converted images are output as is withoutcropping UHD images.Crop Images with FHD cropped from UHD images areoutput.The images output in this case are those with the cropframe specified in [Crop Out].This is only enabled when [UHD Crop] is set to [On].Crop Out [YL, G, MG]Make the settings for the crop frame for images output to the 3G SDIOUT connector and IP.YL Output the yellow crop frame images.G Output the green crop frame images.MG Output the magenta crop frame images.This is only enabled when [UHD Crop] is set to [On].• The color frame specified in [Crop Out] will be a deeper shade whencompared to other colors used for frames.60Camera menu items (continued)