Panasonic BL-WV10 Getting Started

Also see for BL-WV10: Brochure & specs Operating instructions

Contents

Panasonic BL-WV10 Getting Started Manual pdf 27 page image

Getting Started27English2.3 Sequential Display Mode Error Messages2.4 SD Memory Card Error MessagesError Message Causes and SolutionsSequential Display modeis active.Set mode switch on backof unit to NORMAL, thenturn unit off/on. (EG1)This error is displayed when the remote control isused during sequential display mode.• To use the BL-WV10 in normal operationmode, set the mode switch to NORMAL, thenturn the BL-WV10 off and then on again.Error Message Causes and SolutionsSD Memory Card islocked.Unlock the SD MemoryCard and try again. (EJ1)This error is displayed when an SD memory card’swrite-protection is on.• Turn the write-protection off.No SD Memory Card.Insert card and try again.(EJ2)This error is displayed if an SD memory card has notbeen inserted.• Insert an SD memory card.SD Memory Card is full.(EJ3)This error is displayed if there is no free space on theSD memory card.• Insert a blank SD memory card, or eraseunneeded data from it.Cannot use this SDMemory Card. (EJ4)This error is displayed when an SD memory card notrecognized by the BL-WV10 is used.• Use a recognizable SD memory card orformat it using the BL-WV10 (see “ViewingSD Memory Card Information” on page 106 ofthe Operating Instructions).Could not format. (EJ5) This error is displayed when memory card formattingfails.• Re-format the card. If that fails to correct theproblem, use a different SD memory card.