Panasonic BL-WV10 Getting Started

Also see for BL-WV10: Brochure & specs Operating instructions

Contents

Panasonic BL-WV10 Getting Started Manual pdf 39 page image

Getting Started39English3.10 Camera Images, Screen DisplayIssue Causes and SolutionsThe image is out of focus. The lens is dirty.• Clean the lens. Refer to the operatinginstructions included with the camera forinformation.The subject is too close.• The camera cannot properly focus onsubjects less than 0.5 m away. Move thesubject further away (at least 0.5 m from thecamera).The image is out of focus(when using a camerawith an optical zoomfeature).When setting the home position, sensor position, orpreset position, manual focus mode was selected.• If manual focus mode was selected whensetting the home position, sensor position, orpreset position, the image may be out offocus. Set the position again using automaticfocus mode.Manual focus mode is selected.• Press and hold the left or right navigator keyto focus, or press and hold STOP to switch toautomatic focus mode.The subject is too close to the camera.• If the subject is too close, or depending on thezooming position, the image may become outof focus. Move the subject further away fromthe camera or adjust the zoom.Images colors are wrong. The white balance is set incorrectly.• Set the white balance in the camera’s Setupscreen (see “Camera Setup for LocalCameras” on page 93 of the OperatingInstructions).I cannot turn color nightview mode on/off.This feature can be turned on/off for HCM camerasonly by accessing the camera with a PC. For BL-C10and BL-C30, this feature turns on and offautomatically.