Panasonic CZ-256ESMC3 Technical Data Manual

Also see for CZ-256ESMC3: Quick reference Operating instructions

ー 101 ーOperating Instructions Intelligent Controller110Displaying data in graphsEnergy saving5 Touch [DispItem set].z The “DispItem set” screen is displayed.56 Select how to display.z Refer to P.106 for information about how to display.6(The following explains using examples as if “UntCmpar” wasselected)7 Select the unit.z Refer to P.106 for information about units.78 Select the type of graph.z Refer to P.106 for information about types of graphs.z If you have selected [Rankng] as the display method,select either “Worst” or “Best”.89 Set the display units for the Y axis.(1) Touch [Ax1].z The “Unit setting” dialogue is displayed.z Select the display units for the Y axis.9- 1(2) Touch the unit to display.z The settings are registered and the “Unit setting” dialoguecloses.9- 2Continued on next pageGraphing operating times and energy usage111Displaying data in graphsEnergy saving10 Select the item.z Refer to P.107 for the items you can set.z You can select one item only.1011 Select the device name.z Put a check mark in the “Sel.” column.z If you have selected “Rankng” as the display method and“SepUnt” as the graph type, all devices are the target, soyou do not have to select.11Notey The number of units you can select depends on thesettings for display method and graph type.Display method Graph typePlel CumultveUntCmpar Up to 4 Up to 4ChngPrDy 1 only 1 only12 Set the goal values for the axis.z Touch [Ax1TgtVal] and enter the numbers with thetouchscreen numeric keypad.z A red line is inserted to indicate the goal values for thegraph.z You can set any goal.z This cannot be set if you have selected “Rankng” as thedisplay method.1213 Touch [GraphDsp].z The graph is displayed in the main screen.z To cancel the settings, touch [Cancel].13Graphing operating times and energy usage