Panasonic CZ-256ESMC3 Technical Data Manual

Also see for CZ-256ESMC3: Quick reference Operating instructions

ー 97 ーOperating Instructions Intelligent Controller102Settings for energy savingEnergy saving9 Set the times.z The time on the left is the control start time. The time onthe right is the control end time.z Use to set the time. Hours can be set in therange 0 to 23, and minutes may be either “00” or “30”.910 Touch [Register].z The “Term setting” dialogue closes.z To cancel the settings, touch [Cancel].1011 Put a check mark in the “Valid” column.11Continued on next pageItem ExplanationO/D unit cyclicValidThe O/D unit cyclic function is enabled for theselected outdoor unit if you put a check markhere.5 Touch [Register].z The “Setting” dialogue closes.z To cancel the settings, touch [Cancel].56 Set other indoor units.z Repeat steps 3 to 5.7 Touch [Timer set.].z The “Term setting” dialogue is displayed.78 Touch the number.z You can set 4 different time slots.8Control operation at regular intervals [O/D unit cyclic]103Settings for energy savingEnergy saving12 Select “Yes” for “O/D unit cyclic”.1213 Touch [Register].z To cancel the settings, touch [Cancel].13Notey Up to 5 control groups can be created.y Control groups that have not been set will not be the object ofcyclic control.The “O/D unit cyclic” screenA: [Select all]/[Clear all] buttons[Select all] Select all outdoor units.[Clear all] Cancel selection of alloutdoor units.B: Set whether to enable outdoor unit cycling controlacross the whole system or not.Notey If you select “Yes”, make sure that you set“No” for indoor unit cycling control settings.C: Change list order. The list order changes eachtime you touch it.Display The display follows the order setin “I/D unit settings” (P.141).O/D unit The display follows the addressorder of the outdoor unit systems.Address The display follows the addressorder set in “I/D unit settings”(P.141).D: The outdoor units with a check mark next tothem will be the subject of the changes to thesettings.E: The O/D unit cyclic is enabled for the selected outdoor unit if you put a check mark here. This is linked with the “O/D unit cyclicValid” (“Setting” dialogue) (P.102) setting.F: The “Term setting” dialogue is displayed when you touch this.G: The “Setting” dialogue is displayed when you touch this.ACBEGFDControl operation at regular intervals [O/D unit cyclic]