108RQT9431Software UpdateSoftware of this unit can be updated automatically byfollowing method.From broadcastsFrom Internet [network connection and setting is required.(➔ 106, 112)]Update of the software is done when it is in standby mode.Once the new software is found, it will start the download ofthe software, and then update.Download of the software will start automatically when thepower of this unit is turned in standby or when it is 3 a.m.The time it takes to update depends on the connection.For Broadcast: About 1 hour. (It may change depending on thecondition of the broadcast.)For Internet: About 1 hour (It may take longer than specifiedabove to download because the download time differs dependingon the network environment. It is recommended to be used in abroadband environment.)If you do not want to perform the software update during thestandby mode, set “Software Update in Standby” in the Setupmenu to “Off”. (➔ 104)If a software update is available, anotification is displayedUpdate of the software will start when the power is turnedoff.To start downloadingPress [OK].To ignore the new softwarePress [EXIT].The unit’s display during the update“SW-DL” : Software is downloading. Download will stopwhen the power is turned on, or the timerrecording starts.“START” Ú : Update of the software will start once thedownload is completed.“UPD
/
”Ú : Software is updating.“FINISH” : Updated of the software has completed.Ú You cannot operate the unit until the update is complete.Removing the AC mains lead while the update is in progressmay damage the unit.NotesIf the timer recording is scheduled within the following time at thestart of the download, the download will not be executed.For broadcast: Within 4 hoursFor Internet: Within 1 hourIf downloading on this unit fails or this unit is not connected tothe Internet, then you can download the latest software from thefollowing website and burn it to a CD-R to update the software.http://panasonic.net/support/•••––••••••––•
