42RQT9431TipsYou can enter up to 32 programmes a month in advance.(Each daily, weekly or series timer recording is counted as oneprogramme.)To exit the timer recording listPress [PROG/CHECK].NotesRecording may fail if there are changes to the station’s programming.“z” disappears from the unit’s display when no timer programme isset or when all timer programmes are deactivated.“-------” is displayed on a series recording item if there will be noepisode of the series for the next 8 days. We recommend youdelete the “-------” item after you confirm the last episode of theseries is recorded.The “Guide Link” function may not work if you manually change thestart/end time by over 10 minutes.The “Guide Link” function may not work if you manually change thestart time later or the stop time earlier than the original time.Programmes that failed to record are deleted from the timerrecording list at 4 a.m. two days later.To deactivate timer programme(e.g. to interrupt a daily or weekly timerprogramming)After performing step (➔ Previous page)(Red)“z” on the timer recording list turns gray.Press the “Red” button again to activate timerprogramme.––•••••••Notes on timer recordingTimer recording will not be performed if the clock is not set.During recording, timer recording standby or EXT LINKstandby, this unit cannot play discs or titles that do notmatch the “TV System” setting. It is recommended “TVSystem” be set to match the discs or title before playingthem. But to prevent the failure of the timer recording,change back the settings before the recording starts. (➔101)Timer recordings are activated regardless of whether theunit is turned on/in standby.Timer recordings begin when the set time is reached evenwhen playing.Timer recordings do not begin while copying in normalspeed mode.If the unit is turned on when timer recording begins, itremains turned on after recording finishes. It does notturn off automatically. You can turn the unit off during timerrecording.When you programme successive timer recordings to startimmediately one after the other, the unit cannot record thepart at the beginning of the later programmes.ProgrammeProgrammeRecordedRecordedNot recordedThe “Overlapped Timer Recording” screen may be displayedimmediately after you turn on this unit, if new overlappingoccurred. Refer to “Check, Change, Delete Programmes, orResolve Overlapping” (➔ 41).••••••••Advanced Timer Recording HDD
