Panasonic DMR-E30 Operating Instructions Manual

Also see for DMR-E30: Operating instructions Installation instructions Operating instructions Bedienungsanleitung

Contents

important safety instructions

12RQT6559Getting startedSTEP 3 Plug-in Auto Tuning1 Press [SETUP] to show the menus.2 Press [3, 4] to select “Channel”and press [1].3 Press [3, 4] to select “Antenna Sys-tem” and press [ENTER].4 Press [3, 4] to select “TV” or“CATV” and press [ENTER].TV: TV broadcast (2CH–69CH)CATV: CATV broadcast (1CH–125CH)The screen shown in step 2 reappears.5 Press [3, 4] to select “Auto ChannelSetting” and press [ENTER].If you have not yet set clock, the “Auto Channel/Clock Set-ting” screen appears.6 Press [ENTER].Auto setting starts. This takes a few minutes. (To stop autochannel setting, press [RETURN].) When finished, the Com-plete screen or time display is shown. Press [ENTER].To return to the previous screenPress [RETURN].When you are finishedPress [SETUP].While this unit is receiving the antenna signal (but not duringrecording):1 Press the numbered buttons to selecta channel.Example: “5”: [0] ➜ [5]“15”: [1] ➜ [5]“115”: [100] ➜ [1] ➜ [5]≥You can also use [W, X, CH] when you are going to deletea channel.2 Press [ADD/DLT].The channel is deleted if it was set or added if it was not set.For exampleRepeat steps 1 and 2 as necessary.If Plug-in Auto Tuning failsDVD/TVDVDVCR Plus+ TV/VIDEO REC MODE RECCHVOLUMETVTVDVD1 2 37 8 90 1004 5 6SLOW/SEARCHSKIPDIRECT NAVIGATORTOPMENUMENURETURNFUNCTIONSPROG/CHECK DISPLAY TIME SLIPADD/DLTENTERPLAY LISTCANCELPOWERÍ ÍOPEN/CLOSESETUPERASE F Rec POSITION MEMORY MARKERAUDIO INPUT SELECT CM SKIPSTATUS FRAME2≥3≥4≥5≥6RETURN1121TAB SELECTAntenna SystemAuto Channel SettingChannel CaptionPreset Channel CaptionManual Channel CaptionVCR Plusi CH SettingCATVChannelSET UPRETURNSet UpDiscVideoAudioDisplayTV ScreenTABSELECTAntenna SystemAuto Channel SettingChannel CaptionPreset Channel CaptionManual Channel CaptionVCR Plusi CH SettingCATVRETURNSet UpDiscVideoAudioDisplayTV Screen ENTERChannelSET UPSET UPSet UpVideoChannelSELECTAntenna SystemTVCATVDiscAdding and deleting channelsSET UPSet UpDiscVideoAudioDisplayChannelAuto Channel SettingConnect antenna cable and if you use acable box, tune it to your local PBS CHthen...Please push the ENTER key.Unit's displayCHANNEL 12 DELETED13RQT6559Getting startedSTEP 4 VCR Plusi guide channel settings !?Set these guide channels so you can use VCR Plusi codes fortimer recording. Before starting the settings, prepare a chart show-ing the channels, station names, and guide channels.For example:A The guide channel and channel numbers correspond so you donot have to change the setting.B In step 5, enter channel 15 next to Guide Channel 33.C In step 5, enter channel 20 next to Guide Channel 38.1 Press [SETUP] to show the menus.2 Press [3, 4] to select “Channel” andpress [1].3 Press [3, 4] to select “VCR PlusrCH Setting” and press [ENTER].For example, when the current antenna system is CATV.4 Press [3, 4] to select the guidechannel you want to set and press[1].When selecting the guide channel, press and hold [3, 4] toscroll the screen up and down.5 Press [3, 4] to select the channelcorresponding to the guide channeland press [2].To delete a number, press [CANCEL].Repeat steps 4 and 5 as necessary.6 Press [ENTER].The screen shown in step 2 reappears.To return to the previous screenPress [RETURN].When you are finishedPress [SETUP].StationnameGuidechannelChannelnumberCBS 04 04 ➜ AHBO 33 15 ➜ BNickelodeon 38 20 ➜ CVOLUME7 8 90 100SLOW/SEARCHSKIPDIRECT NAVIGATORTOPMENUMENURETURNFUNCTIONSPROG/CHECK DISPLAY TIME SLIPADD/DLTENTERPLAY LISTCANCELOPEN/CLOSESETUPERASE F Rec POSITION MEMORY MARKERAUDIO INPUT SELECT CM SKIPSTATUS FRAME2≥3≥4≥5≥6RETURNCANCEL1Look up the guide channelsfor the stations in magazines.Write down all the stations youcan receive.TAB SELECTAntenna SystemAuto Channel SettingChannel CaptionPreset Channel CaptionManual Channel CaptionVCR Plusi CH SettingCATVChannelSET UPRETURNSet UpDiscVideoAudioDisplayTV ScreenTABSELECTAntenna SystemAuto Channel SettingChannel CaptionPreset Channel CaptionManual Channel CaptionVCR Plusi CH SettingCATVRETURNSet UpDiscVideoAudioDisplayTV Screen ENTERChannelSET UPSET UPSet UpDiscVideoAudioDisplayTV Screen ENTERVCR PlusiCH SettingGuide Channel CATV Channel------1251------RETURN23SELECTChannelENTERVCR PlusiCH SettingGuide Channel CATV Channel---456------RETURN78------SELECTSET UPChannelSet UpDiscVideoAudioDisplayTV ScreenENTERVCR PlusiCH SettingGuide Channel CATV Channel---456------RETURN7812---SELECTSET UPChannelSet UpDiscVideoAudioDisplayTV Screen