Panasonic DMR-EZ28K Operating Instructions Manual

Also see for Diga DMR-EZ28: Help guide Operating instructions Quick setup guide

Contents

68RQT9046Error MessagesOn the Unit’s Display PageH , F(“ ” stands for a servicenumber.)An error has occurred. The number following “H” or “F” depends on the status of the unit.Check the items below and in the Troubleshooting Guide. If the service number still doesnot disappear after the check, reset the unit (➔ 70, “To restore the unit if it freezes” ).• −If the service numbers fail to clear, note the service numbers andcontact a qualified service person.• −RC (“ ” stands for anumber.)The remote control and the main unit are using different codes.Change the code on the remote control.• 48HARD ERR(“HArd” and “Err” arealternately displayed.)If there is no change after turning the unit on and off, consult thedealer where the unit was purchased.• −NO READ(“NO” and “REAd” arealternately displayed.)The disc is dirty or badly scratched. The unit cannot record, play, or edit.• 63The disc may be incompatible or of poor quality.• 62, 63,65You have used a lens cleaner and it has finished operation. Press[; OPEN/CLOSE] on the main unit to eject the disc.• 3Displayed when the unit is started. This is not a malfunction.• −The unit is carrying out its recovery process. You cannot operate theunit while “ ” is displayed.• −FULL There are already 16 scheduled recording programs. Deleteunnecessary scheduled recording programs.• 23UNSUPPORT(“UNSUP” and “POrt” arealternately displayed.)You have inserted a disc the unit cannot play or record on.You tried to operate with a non-compatible USB memory.••62, 6364UNFORMAT(“UNFOr” and “MAt” arealternately displayed.)You have inserted a new DVD-RW/+RW or a DVD-RAM/DVD-RW(DVD-Video format) recorded on other equipment. You can format thedisc when the format confirmation screen is displayed.• 21, 44“ ” is displayed on theunit’s display.This unit is confirming that it is connected with equipment compatiblewith HDAVI Control.• −F74 The HDMI connection could not be authenticated due to a transfermalfunction. Consult the dealer where the unit was purchased.• −F75 The HDMI connection could not be authenticated due to an internaldata malfunction. Consult the dealer where the unit was purchased.• −U59 The unit is very warm.The unit switches to standby for safety reasons. Wait for about 30 minutesuntil the message disappears. Reinstall the unit in an area with adequateventilation. Do not block the cooling fan on the rear of the unit.• −U61 There was a power failure or the AC power supply cord was disconnected while theunit was on. The unit is carrying out its recovery process. This process restores theunit to normal operation. The unit is not broken. Wait until the message disappears.• −U72U73The HDMI connection acts unusually.The connected equipment is not HDMI compatible.Please use HIGH SPEED HDMI cables that have the HDMI logo (as shown on the cover).The HDMI cable is damaged.•–––−U76 HDMI cannot be output because you are connected to a model thatdoes not support copyright protection.• −U88 There was something unusual detected with the disc while recordingor playing; there was a power failure or the AC power supply cordwas disconnected while the unit was on. The unit is carrying out itsrecovery process. This process restores the unit to normal operation.The unit is not broken. Wait until the message disappears.• 71U99 The unit fails to operate properly. Press [POWER ^/I] on the main unit to switchthe unit to standby. Press [POWER ^/I] on the main unit again to turn the unit on.• −