129 JAN 2006Ver. 5.2DP-3510/3520/3530/4510/4520/4530/6010/6020/6030Note:1. Clean all Rollers and Separation Rubber with a soft cloth saturated with water.For stubborn toner accumulation, wipe with a soft cloth saturated with Isopropyl Alcohol first, thenfollow up with a soft cloth saturated with water.2. The Maintenance Cycle is based on the Counter Information for each individual module.To verify the counter information, print the Total Counter List using the Service Mode: F7 - Electroniccounter - 00 (List print).3. Cleaning, Replacement and Adjustment Cycle (Sheet) are based on using Panasonic's recommendedstandard paper and supplies. These cycles may vary with the kind of paper used and/or ambientconditions.4. The value is determined under the following test conditions. Four continuous prints per job using 6%image coverage of LT/A4 size.5. 240K or 1 year whichever occurs first.3.5. Resetting the P/M (Preventive Maintenance) CounterWhen the machine reaches the preset P/M Cycle, it will show “Call for P/M” or “Replace The Toner WasteContainer” on the LCD Display. The PM Counter can be reset by following the procedures below.3.5.1. “Call for P/M” (Default: 120K (DP-35xx/45xx), 240K (DP-60xx))1. Perform the P/M (Preventive Maintenance). Refer to Section 3.3 and 3.4.2. Press the "FUNCTION", "ORIGINAL SIZE (LEDGER/A3)" and "3" keys simultaneously in that orderto enter the Service Mode.3. Enter the Copy Service Mode F5-70 (PM cycle) and change to the desired value.4. Press “FUNCTION” and “C (CLEAR)” keys simultaneously to exit the Service Mode.3.5.2. “Call for P/M Fuser Web” (Default: 240K)1. Perform the P/M (Preventive Maintenance). Refer to Section 3.3 and 3.4.2. Press the "FUNCTION", "ORIGINAL SIZE (LEDGER/A3)" and "3" keys simultaneously in that orderto enter the Service Mode.3. Enter the Copy Service Mode F5-73 (Fuser web) PM cycle and change to the desired value.4. Press “FUNCTION” and “C (CLEAR)” keys simultaneously to exit the Service Mode.3.5.3. “Call for P/M ADF” (Default: Not shown)1. Perform the P/M (Preventive Maintenance). Refer to Section 3.3 and 3.4.Sheet Bypass54 Paper Feed Roller 4608 120K Water 1 240KRefer toSect 2.2.14.F7-03SheetBypassCount55 Feed Roller 4612 120K Water 1 240K56 Pickup Roller 4603, 4611 120K Water 1 240KPaper Exit Transportation57 Exit Roller 2 8120 120K Water 1 - Refer toSect 2.2.15. F7-02Total Count58 Exit Roller 3 8312 120K Water 1 -3000-Sheet Large Capacity Tray59 Paper Feed Roller 9111 120K Water 1 240K Refer toSect 2.2.19.F7-03LCT TrayCount60 Feed Roller 9129 120K Water 1 240K61 Pickup Roller 9107 120K Water 1 240KNo. Mechanical Parts Ref. No.Cleaning Replacement/Adjustment Ref.CounterCycle(Sheet) Method Cycle(Sheet) Procedure
