52RQT8856System SettingsTo Others Setup(➔ 46, Accessing the Setup Menu)All factory default settings are indicated with “Underlined” text.Otherse, r select “Others” ➔ q ➔ e, rselect item ➔SetupTuningDiscPictureSoundDisplayConnectionOthersRemote ControlClockOwner IDPower SaveDVD 1SELECTTABRETURNSystem UpdateOnInitializeRemote Control (➔ 61)[DVD 1] [DVD 2] [DVD 3]Clock (➔ 11)Owner ID (➔ 10)In order to prevent another person from using this unit if it isstolen, you can set a PIN number and input your personalinformation.Once the PIN number has been set, you cannot return to thefactory preset. Make sure not to forget this.PIN numberNameHouse No.Postcode••••Power SaveRefer to the following when “Power Save” is set to “On”.Power consumption is minimized when the unit is turned off(➔ 74).Startup of the unit becomes slower compared to when “PowerSave” is “Off”.When the unit is off, satellite programmes cannot be watched onthe TV because the signal from the satellite receiver connectedto AV2 input terminal of this unit is not looped through. To watchthem, turn on the unit.•••System UpdateIn order to update this unit, the EPG download, and supportsystem changes made by broadcasts, this unit periodicallyperforms software updates.Press [OK] to display the menu.Update data and EPG download information are sent by anunscheduled digital broadcast. In order to receive these updates,you must be able to receive digital broadcasts.An update and EPG download will take approximately 60minutes. While the update is in progress, “SW-DL” appears on theunit’s display.You cannot operate the unit until the update is complete.Removing the AC mains lead while the update is in progressmay damage the unit.To avoid hearing the startup sound of System Update for theunit, perform the following steps.Select the time for Software Update (➔ right, EPG/Softwaresearch period).Set “EPG Download in Standby” and “Software Update inStandby”(➔ right) to “Off”, and update manually (➔ right,Software Update Search Now).Set “Power Save”(➔ above) to “On”.••••–––EPG Download in Standby[On] When the unit is turned off, EPG data is downloadedautomatically.[Off]Software Update in Standby[On] You can perform the unit updates automatically whenthe unit is turned off.[Off]EPG/Software search periodSelects the time to automatically perform EPG download andupdates when the unit is turned off. This can only be set when“EPG Download in Standby” and “Software Update in Standby” isset to “On”.If there is a programmed recording set for the time you haveselected, the programmed recording will be given priority.[Automatic] The unit will give priority to searching for update dataat midnight.[02:00-06:00] [06:00-10:00] [10:00-14:00][14:00-18:00] [18:00-22:00] [22:00-02:00]•Software Update Search NowStart the search for new software manually.A new software version is announced by a message. Do notswitch your unit off during the update. This could result in the lossof data. A message shows that the update has finished. If a newsoftware version is not going to be broadcast until the next fewdays, a corresponding message also appears.If applicable update data is found, press [w, q] to select “Yes”and press [OK].•InitializePress [OK] to show the following settings.Shipping ConditionThis returns Setup menus to default settings, except for theratings level, ratings password, Owner ID and Clock.[Yes] [No]The timer recording programmes are also cancelled.•Default SettingsThis returns Setup menus to default settings, except for theprogrammed channels, time settings, disc language settings,ratings level, ratings password, Owner ID and remote controlcode.[Yes] [No]