Chapter 4 Settings — [OPTION] menu48 - ENGLISH[OPTION] menuSelect [OPTION] from the main menu, and select the item from the sub-menu.Refer to “Navigating through the menu” (x page 38) for the operation of the menu screen.f After selecting the item, press asqw to adjust.[ON-SCREEN SETTING]Set the on-screen display.Setting [OSD DESIGN]Set the color of the menu screen (OSD).1) Press as to select [ON-SCREEN SETTING].2) Press the button.f The [ON-SCREEN SETTING] screen is displayed.3) Press as to select [OSD DESIGN].4) Press qw to switch the item.f The item is switched every time the button is pressed.[TYPE1] Sets to blue.[TYPE2] Sets to black.Setting [OSD OUTPUT]Set the terminal to output the menu screen (OSD).1) Press as to select [ON-SCREEN SETTING].2) Press the button.f The [ON-SCREEN SETTING] screen is displayed.3) Press as to select [OSD OUTPUT].4) Press qw to switch items.f The item is switched every time the button is pressed.[DVI-D/DIGITAL LINK] The menu screen (OSD) is displayed in the output image from the terminal, the terminal, and the terminal.[DVI-D] The menu screen (OSD) is displayed only in the output image from the terminal.Notef When the [OSD OUTPUT] is set to [DVI-D/DIGITAL LINK], the menu screen (OSD) is not displayed on any image display device screenconnected to the terminal or the terminal if the connection status is as follows. Operate after turningon the power of the image display device connected to the terminal.g Displays (projector or flat panel display) are connected to both the terminal and the terminal.g Display connected to the terminal is in standby mode.If the display connected to the terminal cannot be turned on due to defect, etc., press and hold the button on the control panel of this device for 3 seconds or longer. The menu screen is forcefully output to the output image of all the outputterminal.f The menu screen (OSD) is not displayed when the 3D signal is output from the device.[COMPUTER IN]Change the setting if the correct image is not displayed when the Y/C signal is input to the device, or whenconnected to an external device using the terminal and the terminal.Setting [COMPUTER 1 INPUT SETTING]Set in accordance to the signal input to the terminal.1) Press as to select [COMPUTER IN].
