Chapter 4 Settings ā [OPTION] menuENGLISH - 53[DVI-D OUT]Perform the setting of the output signal from the terminal.1) Press as to select [DVI-D OUT].2) Press the button.f The [DVI-D OUT] screen is displayed.3) Press as to select [FRAME LOCK].4) Press qw to switch items.f The item is switched every time the button is pressed.[OFF] Disables [FRAME LOCK].[ON]Synchronizes the output signal from the terminal with the vertical scanning frequencywhen a moving image signal is input, preventing the image from being jumpy due to frame jump.The output resolution is automatically set by the input signal.f Image is output with the same resolution as the input signal when 720p signal/1080p signal is input.720p signal: 720/60p, 720/50p1080p signal: 1080/24p, 1080/25p, 1080/30p, 1080/60p, 1080/50pf Image is output with the resolution of 1 920 x 1 080 dots when a moving image signal other thanthe 720p signal/1080p signal is input.Target signal: NTSC/NTSC4.43/PAL-M/PAL60, PAL/PAL-N/SECAM, 480i, 576i, 480p, 576p,1080/60i, 1080/50if Image is output by automatically adjusting to the resolution of the image display device connectedto the terminal when a still image signal is input. However, if the resolution of theimage display device cannot be determined, the image is output in resolution of 1 920 x 1 080 dots.f When [OFF] is selected, advance to Step 5).5) Press as to select [OUTPUT RESOLUTION].6) Press the button.f The [OUTPUT RESOLUTION] screen is displayed.7) Press as to switch items.f The item is switched every time the button is pressed.[AUTO] Outputs the image by automatically adjusting to the resolution of the image display device connectedto the terminal.[1920x1200] Outputs the image in 1 920 x 1 200 dots.[1920x1080] Outputs the image in 1 920 x 1 080 dots.[1400x1050] Outputs the image in 1 400 x 1 050 dots.[1366x768] Outputs the image in 1 366 x 768 dots.[1280x800] Outputs the image in 1 280 x 800 dots.[1024x768] Outputs the image in 1 024 x 768 dots.Notef Image may not be displayed depending on the connected image display device when [OUTPUT RESOLUTION] is set to anything other than[AUTO]. In such case, press the button on the control panel 4 times, and then press the button and the button simultaneously to forcefully change [OUTPUT RESOLUTION] to [AUTO] for both [DVI-D OUT] and [DIGITAL LINK OUT].f Image is output with appropriate resolution and tone for the connected image display device when [FRAME LOCK] is set to [ON], but it maytake some time for the image to be output at the time of switching the input or switching the signal.f [OUTPUT RESOLUTION] cannot be set when [FRAME LOCK] is set to [ON].f The terminal does not support the output of 3D signal.f When [FRAME LOCK] is set to [ON], the [OPTION] menu ā [BACKUP INPUT SETTING] (x page 57) cannot be set.Setting the audio output for cascade connectionSet the audio signal output from the terminal when cascade connection (multiple deviceconnection) is performed with the device.The [CASCADE] setting is enabled when [AUDIO OUT SELECT] is set to [DIGITAL LINK].1) Press as to select [DVI-D OUT].
