Chapter 4 Settings ā [OPTION] menu52 - ENGLISH[DIGITAL LINK OUT]Perform the setting of the output signal from the terminal and the terminal.1) Press as to select [DIGITAL LINK OUT].2) Press the button.f The [DIGITAL LINK OUT] screen is displayed.3) Press as to select [FRAME LOCK].4) Press qw to switch items.f The item is switched every time the button is pressed.[OFF] Disables [FRAME LOCK].[ON]Synchronizes the output signal from the terminal and the OUT 2> terminal with the vertical scanning frequency when a moving image signal is input, preventingthe image from being jumpy due to frame jump.The output resolution is automatically set by the input signal.f Image is output with the same resolution as the input signal when 720p signal/1080p signal is input.720p signal: 720/60p, 720/50p1080p signal: 1080/24p, 1080/25p, 1080/30p, 1080/60p, 1080/50pf Image is output with the resolution of 1 920 x 1 080 dots when a video signal other than the 720psignal/1080p signal is input.Target signal: NTSC/NTSC4.43/PAL-M/PAL60, PAL/PAL-N/SECAM, 480i, 576i, 480p, 576p,1080/60i, 1080/50if Image is output by automatically adjusting to the resolution of the display (projector or flat paneldisplay) connected to the terminal or the terminalwhen a still image signal is input. However, if the resolution of the display cannot be determined,the image is output in resolution of 1 920 x 1 080 dots.f When [OFF] is selected, advance to Step 5).5) Press as to select [OUTPUT RESOLUTION].6) Press the button.f The [OUTPUT RESOLUTION] screen is displayed.7) Press as to switch items.f The item is switched every time the button is pressed.[AUTO] Outputs the image by automatically adjusting to the resolution of the display (projector or flat paneldisplay) connected to the terminal or the terminal.[1920x1200] Outputs the image in 1 920 x 1 200 dots.[1920x1080] Outputs the image in 1 920 x 1 080 dots.[1400x1050] Outputs the image in 1 400 x 1 050 dots.[1366x768] Outputs the image in 1 366 x 768 dots.[1280x800] Outputs the image in 1 280 x 800 dots.[1024x768] Outputs the image in 1 024 x 768 dots.Notef Image may not display depending on the connected image display device when [OUTPUT RESOLUTION] is set to anything other than[AUTO]. In such case, press the button on the control panel 4 times, and then press the button and the button simultaneously to forcefully change [OUTPUT RESOLUTION] to [AUTO] for both [DIGITAL LINK OUT] and [DVI-D OUT].f Image is output with appropriate resolution and tone for the connected display when [FRAME LOCK] is set to [ON], but it may take sometime for the image to be output at the time of switching the input or switching the signal.f To output the 3D signal, set [FRAME LOCK] to [ON]. 3D signal is not output when set to [OFF].f [OUTPUT RESOLUTION] cannot be set when [FRAME LOCK] is set to [ON].f When the displays are connected to both the terminal and the terminal, and [FRAMELOCK] is set to [ON] to input the still image signal, the image is output matching the resolution of the display connected to the LINK OUT 1> terminal.f When the displays (projector or flat panel display) are connected to both the terminal and the OUT 2> terminal of the device and [OUTPUT RESOLUTION] is set to [AUTO], the image is output matching the resolution of the displayconnected to the terminal.f When [FRAME LOCK] is set to [ON], the [OPTION] menu ā [BACKUP INPUT SETTING] (x page 57) cannot be set.
