Setup15When placing media in the tray, refer to the instructionsbelow.When using the multi-purpose tray, refer to page 16.CAUTION:• Be sure to hold the media tray with both hands so thatyou do not drop it. The media tray weighs approximately6.4 kg (14 lbs.) when it is fully loaded.NOTE:• When the tray cover is open or the multi-purpose tray isused, you cannot pull the media tray out of the printer oropen the front door.Be sure to close the multi-purpose tray and the traycover before pulling the media tray out of the printer oropening the front door.1 Pull the media tray (1) out of the printer while slightlyraising its front portion and remove the tray pad (2).2 Pinch the media guides and slide them to the width ofthe media.3 Slide the length guide unit to adjust it to the medialength. Slide the length guide unit (2) while pressingthe PUSH mark (1) to extend it.NOTE:• When adjusting the length guide unit to the medialength, make sure the slide stopper of the lengthguide unit is fixed by the slit of the media tray.4 Tap the media stack on an even surface to avoidmedia jams or skewed printing.NOTES:• Be careful not to leave fingerprints on the media,which can result in a smudged print.• Reusing media (used paper or jammed paper) thathas been fed through the printer once can reducethe life of the consumables and paper pathcomponents.TrayUsing the Media TrayMedia Type Media Weight Media SizePlain paperBond/LetterheadRecycled paper75 - 105 g/m2(20 - 28 lb.) Letter, Legal, A4,B5 (JIS)Thin paper 60 - 75 g/m2(16 - 20 lb.)Tray cover12Media guidesSlide stopperLength guide unitSetup