Panasonic KX-CL400 Setup Manual

Also see for KX-CL400: Brochure & specs Brochure & specs Operating instructions

17Settings and PrintingNOTES:• Loading media exceeding the upper limit maycause a media jam or miss feed.• When printing on envelopes, close the flap andinsert with the flap side on the left side into themulti-purpose tray.• Envelopes with openings on the shorter edgecannot be used.• When printing on some types of envelope, a wrinklemay occur. For detailed information, refer to"Envelope Specifications" in the Maintenance andSpecifications section.• When printing on transparencies, refer to “Usingthe Multi-purpose Tray” of the Basics in theSettings and Printing section.4 Pull the paper support (1) and raise (2) so that themedia does not drop from the output tray.Connect the power cord to the printer. Turn the printer on.The Power indicator lights. After the printer is ready, theReady indicator also lights and Ready is displayed on theprinter LCD panel.NOTES:• If Self Calibration is performed, it will take some time tocomplete.• When the printer enters Power Save mode, the Powerindicator will start blinking and Power Save will bedisplayed on the printer LCD panel.• When you turn on the printer for the first time, it will takeabout 5 minutes to fill the printer with toner. When theprocess is completed, Ready is displayed on the printerLCD panel.• English* is the default language. (* denotes the defaultsetting.)• Select English, German, French, Spanish or Italian asthe language that appears on the LCD panel.1 Press Menu/Exit (Pause) button to enter Menumode.2 Press S button until the System menu appears.3 Press X button.The Language menu appears.4 Press X button.The English* menu appears.5 Press S button until the desired language isdisplayed.6 Press Enter button to activate your selection.It is possible to confirm the printer's settings by printingthe Configuration Page as below.If the printer is connected to the network, consult with thenetwork administrator for the printer’s network settingbefore printing the Configuration Page. For detailedinformation, refer to “Setting up TCP/IP on the Printer” inthe Installation section.1 Press Menu/Exit (Pause) button to enter Menumode.The System Information menu appears.NOTE:• If the hard disk drive is installed in the printer, pressS button to display the System Informationmenu.2 Press X button.The Menu Map menu appears.3 Press S until the Configuration Page menuappears.4 Press Enter button.The printer will start printing the Configuration Page.Power OnPaper support 12Setting the LCD LanguagePrinting the ConfigurationPageSettings and Printing