4For Your Safety[ WARNING ]• To prevent fire or shock hazard, do not expose thisproduct to rain or any type of moisture.[ CAUTION ]• The printer weighs approximately 32 kg (70 lbs.). It mustbe handled by two people. Turn the power off andremove the power cord when handling the printer.• Do not place the printer on an uneven or unstablesurface.• Avoid the media tray going across an edge of a desk.Dropping the printer may cause injury.• Do not place the printer in an area where there is a lot ofsmoke, dust, chemical fumes or vibration.• When moving the printer, be sure to unplug the powercord from the AC outlet. If the printer is moved with thepower cord attached, it can cause damage to the cordwhich could result in fire or electric shock.• Take care when handling the media tray or printcartridge because they are heavy. Dropping either maycause injury.[ CAUTION ]• This printer utilizes a laser. Use of controls oradjustments or performance of procedures other thanthose specified herein may result in hazardous radiationexposure.[ WARNING ]• The power source voltage of this printer is listed on thenameplate. Only plug the printer into an AC outlet withthe proper voltage.• When you operate this equipment, the AC outlet shouldbe near the equipment and accessible.• To ensure safe operation the power cord supplied mustbe inserted into a standard three-prong AC outlet whichis effectively grounded (earthed) through the normalwiring.• The fact that the equipment operates satisfactorily doesnot imply that the power point is grounded (earthed) andthat the installation is completely safe. For your safety, ifin any doubt about the effective grounding (earthing) ofthe power point, consult a qualified electrician.• If the plug cannot be inserted into the AC outlet, contacta licensed electrician to replace the AC outlet with aproperly grounded (earthed) one.• Do not defeat the purpose of the grounding (earthing)plug (ex. do not use a conversion plug).• Plug the power cord firmly into an AC outlet. Otherwise,it can cause fire or electric shock.• Do not attempt to repair, pull, bend, chafe or otherwisedamage the power cord. Do not place a heavy object onthe cord. A damaged cord can cause fire or electricshocks.• Ensure that the plug connection is free of dust. In adamp environment, a contaminated connector can drawa significant amount of current that can generate heatand eventually cause fire if left unattended over anextended period of time.• Never touch a power cord with wet hands. Danger ofelectric shock exists.• Stop operation immediately if your printer emits smoke,excessive heat, abnormal smell or unusual noise.These conditions can cause fire or electric shock.Immediately turn the printer off and unplug the powercord, and contact an authorized service representative.• When disconnecting the printer, grasp the plug insteadof the cord. Pulling on a cord forcibly can damage it andcause fire or electric shock.[ CAUTION ]• Do not leave the power cord plugged into the AC outletif the printer will not be used for an extended period.• Be sure to use the provided power cord. Otherwise, itmay cause fire or electric shock.NoticeInstallation and RelocationLaser SafetyCLASS 1 LASER PRODUCTLaser diode properties (4 provided)Laser output: 5 mW maxWavelength: 785 nmEmission duration: ContinuousPower Source