Panasonic KX-CL400 Setup Manual

Also see for KX-CL400: Brochure & specs Brochure & specs Operating instructions

Settings and Printing18Three types printer to computer connections exist.NOTE:• If you do not have a network, parallel or USB interfacecable, you may need to purchase one.[A] When using the network interface cable:NOTES:• Use category 5 shielded twisted pair cable with RJ-45connectors.• Do not connect connectors other than 100Base-TX /10Base-T. Excessive current flow may cause damage ofthe printer.1 Connect the interface cable from the printer to anetwork device.2 Print the Configuration Page to confirm the IPAddress of the printer.[B] When using the parallel interface cable:NOTES:• Use a shielded cable 2.0 m (6.6 ft.) or less in length.1 Turn off the printer.• Be sure to turn off the printer to avoid the Plug andPlay installation.2 Connect the interface cable from the printer to acomputer.[C] When using the USB interface cable:NOTES:• Use a shielded cable 5.0 m (16.4 ft.) or less in length.• For Windows 98, only Windows 98 SE is available whenusing a USB interface.• Windows NT 4.0 does not support USB interface.1 Turn off the printer.2 Connect the interface cable to a computer.• Be sure to turn off the printer and not to connect theinterface cable to the printer to avoid the Plug andPlay installation.KX-CL400 or KX-CL600 is the model of the PCL printer. Ifyou install an Upgrade Kit (for PostScript 3) in the printer,the model name displayed on the printer driver and utilitywindow becomes KX-CL410 or KX-CL610 respectively.KX-CL410: KX-CL400 with Upgrade KitKX-CL610: KX-CL600 with Upgrade KitThe following steps are for when installing the printerdriver for the KX-CL400 or KX-CL410. For other models,replace the model name with the actual one.The following is the list of drivers and utilities included inthe printer CD-ROM provided with the model of the PCLprinter or Upgrade Kit. To install the driver, refer to thefollowing steps.To install utilities, refer to the Installation section.■ For Windows9: included –: not included■ For Macintosh (with Upgrade Kit)9: included –: not includedConnecting the Printer to aComputer[B] Parallel interface[C] USBinterface[A] NetworkinterfaceComputerInstalling Driver andUtilitiesContents of the Printer SoftwarePrinter Drivers and Utilities KX-CL400KX-CL600UpgradeKitPCL 6 Printer Driver 9 9PostScript 3 Printer Driver – 9Device Monitor 9 9Embedded Web Launcher 9 9Direct Printing System – 9HDD Utility(with Hard Disk Drive) 9 9Print Media Test Pattern 9 9Network Setup Tool 9 9Web Administrative Tool 9 9Remote MaintenanceSetting Tool 9 9Print Count Manager 9 9Printer Drivers and Utilities KX-CL400KX-CL600UpgradeKitPostScript 3 Printer Driver – 9Status Display – 9Network Setup Tool – 9