9.18 PBX Configuration—[1-1]Configuration—Slot—V-IPCS4—Card PropertyThe properties of the V-IPCS card can be specified.Signaling (PTAP) UDP Port No. (Server)Specifies the UDP port used by the V-IPCS card to transmit and receive PTAP (Panasonic TelephonyAdministration Protocol) data. This must be changed if another network application is using the same port.To change the value displayed here, click Common Settings and set the desired value.Default39300Value Range1024–65535Maintenance Console Location9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card PropertySignaling (MGCP) UDP Port No. (Server)Specifies the UDP port used by the V-IPCS card to transmit and receive MGCP (Media Gateway ControlProtocol) data. This must be changed if another network application is using the same port.To change the value displayed here, click Common Settings and set the desired value.Default32727Value Range1024–65535Maintenance Console Location9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card PropertySignaling (MGCP) UDP Port No. (IP-CS)Indicates the UDP port used to transmit and receive MGCP (Media Gateway Control Protocol) data on theIP-CS side (reference only).Default2427Value Range2427Maintenance Console Location9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property390 PC Programming Manual Document Version 2016-039.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
