12.1.1.1 PBX Configuration—[4-1-1] Extension—WiredExtension—Extension Settings—CLIP GenerateCLIP Generate allows the CLIP numbers for a set of locations in series to be programmed together.Pre-assigned CLIP numbers for those locations will be overwritten.If a number generated here is longer than 16 digits, the additional digits will be discarded.Location Entry—Beginning Entry Location (Ext. Number)Specifies the extension number of the first location to be programmed.DefaultExtension number of port 01 of the first extension card that is installed.Value RangeWired extension numberMaintenance Console Location12.1.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—CLIP GenerateProgramming Manual References12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension SettingsFeature Manual References4.1.15 CLIP (Calling Line Identification Presentation)Location Entry—Number to GenerateSpecifies the number of locations to be programmed.A CLIP number will only be assigned to connected wired extensions, even if the number entered here is largerthan the total number of wired extensions.DefaultDepends on installed cards.Value Range1–total number of connected wired extensionsMaintenance Console Location12.1.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—CLIP GenerateProgramming Manual References12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension SettingsFeature Manual References4.1.15 CLIP (Calling Line Identification Presentation)738 PC Programming Manual Document Version 2016-0312.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
