Multi-unit Operation575 Select “Cancel Base”, then press,.6 Enter “0000” (default handset PIN).L If you changed the PIN, enter it (page32).7 Select the base unit(s) you want tocancel, by pressing the desired base unitnumber.L The selected base unit number(s) willflash.L To cancel a selected base unitnumber, press the number again. Thenumber will stop flashing.8 Press ,.9 Select “Yes”, then press ,.10 Press {ih}.Note:L To register the handset to another baseunit or to the same base unit again, seemanual registration (page 55).Increasing the range of the baseunitYou can increase the range of the base unitby using a DECT repeater. Please use onlythe Panasonic DECT repeater noted onpage 6. Consult your Panasonic dealer fordetails.Important:L Before registering the repeater to thisbase unit, you must turn the repeatermode on.Turning the repeater mode on/off1 Press $ (middle soft key).2 Select Z, then press ,.3 Enter “0000” (default base unit PIN).L If you changed the PIN, enter it (page37).4 Select “Other Options”, then press,.5 Select “Repeater Mode”, then press,.6 Select “On” or “Off”, then press ,.7 Press {ih}.Note:L After turning repeater mode on or off,certain icons displayed on the base unitwill disappear for a moment and w willflash on the handset momentarily. This isnormal. The handset can be used once wstops flashing.L While the repeater mode is turned on,audible call announcements may not beheard from the handset speaker.IntercomIntercom calls can be made betweenhandsets/base unit in the same radio cell.Between a handset and the baseunitWhen a handset calls the base unit1 Handset:Press {INT} and {0}.L The base unit will ring.2 Base unit:Press {s} to answer.3 Handset:When finished talking, press {ih}.Base unit:When finished talking, press {s}.When the base unit calls a handset1 Base unit:Press {x} and the desired handsetnumber.L The handset will ring.TCD340FX(e).book Page 57 Wednesday, June 8, 2005 3:57 PM