4.9 LCR ProgrammingItemized Code Set70034-146.0 System ProgrammingDescription Registers an itemized code applied to an extension.The registered code is inserted into the “I” command positionstored in program [7X22] “LCR Carrier Modify Command.”Selection • Jack number: KX-TD816 – 01 through 16 (-1 / -2)KX-TD1232 – 01 through 64 (-1 / -2)(-1 = first part, -2 = second part)• Itemized code: 4 digits (max.)Default KX-TD816: Jack 01-1 through 16-1 = 201 through 216;Jack 01-2 through 16-2 = 301 through 316KX-TD1232:Jack 01-1 through 64-1 = 201 through 264;Jack 01-2 through 64-2 = 301 through 364Programming 1. Enter 7003.Display: Itemized Code2. Press NEXT.Display: Jack NO?–>3. Enter a jack number.To enter jack number 01, you can also press NEXT. To select thesecond part (-2), press NEXT after entering a jack number.Display example: #01-1: Not Stored4. Enter an itemized code.To delete the current entry, press CLEAR.To change the current entry, press CLEAR and the new code.5. Press STORE.6. To program another jack, press NEXT or PREV, orSELECT and the desired jack number.7. Repeat steps 4 through 6.8. Press END.Conditions • There is a maximum of 32 itemized codes for KX-TD816, and 128itemized codes for KX-TD1232. Each code has a maximum of 4 digits,consisting of 0 through 9.• In the case of KX-TD1232, jack numbers 01 through 32 are for theMaster System and 33 through 64 are for the Slave, if available.Feature References Section 3, Features,Least Cost Routing (LCR)
