Panasonic KX-TG2258CS Operating Instructions Manual

Contents

Useful Information57TroubleshootingCordless TelephoneProblem Cause & Remedy“No link to base. Placeon cradle and tryagain.” is displayed and analarm tone sounds.• You are too far from the base unit. Walkcloser and try again.• Place the handset on the base unit and tryagain.• Plug in the AC adaptor.• Raise the base unit antenna.Static, sound cuts in/out,fades. Interference from otherelectrical units.• Move the handset and the base unit awayfrom other electrical appliances (p. 3).• Walk closer to the base unit.• Raise the base unit antenna.• Select a clearer channel (p. 24, 38, 47).The handset and/or base unitdoes not ring.• The ringer volume is set to OFF. Set to HIGH,MEDIUM or LOW (p. 18).• When the handset is on the base unit, thehandset does not ring. Only the base unitrings when receiving a call.The handset display is blank. • Charge the battery fully (p. 9).You cannot program functionitems.• Programming is not possible while the unit isbeing used.• Do not pause for over 60 seconds whileprogramming.• Walk closer to the base unit.While programming orsearching, the unit starts toring and stops the program/search.• A call is coming in. To answer the call, press[ ], [ ] or [SP-PHONE]. Try again from thebeginning after hanging up.You cannot make a call withthe handset.• Your handset is in remote operation mode(p. 47). Exit by pressing [OFF].You cannot redial. • If the last number dialed was more than32 digits long, the number will not be redialedcorrectly.✿✤✦✪✣✮ ✩ ❇ ✪