Panasonic KX-TG8032AL Operating Instructions Manual

Also see for KX-TG8032AL: Operating instructions

2 MbN: Select the desired setting. aR If you select “Off”, press M N toexit.3 Enter the desired hour and minute youwish to start this feature. aR You can select 24-hour or 12-hourclock format (“AM” or “PM”) bypressing .4 Enter the desired hour and minute youwish to end this feature. a5 M NR When the night mode is set, isdisplayed.Changing the start and end time1 (middle soft key) #2372 Continue from step 3, "Turning nightmode on/off", page 27.Setting the ring delayThis setting allows the handset to ring duringnight mode if the caller waits long enough.After the selected amount of time passes, thehandset rings. If you select “No Ringing”,the handset never rings during night mode.1 (middle soft key) #2392 MbN: Select the desired setting. aa M NNote:R When the answering system answers thecall, this feature does not work.Selecting categories to bypass nightmode1 (middle soft key) #2412 MbN: Select your desired categories. aR “ ” is displayed next to the selectedcategory numbers.R To cancel a selected category, pressagain. “ ” disappears.3 a M NNote:R You can also select the categories in step 2as follows:Press 1 to 9. aChanging the handset nameEach handset can be given a customisedname (“Bob”, “Kitchen”, etc.). This is usefulwhen you make intercom calls betweenhandsets. You can also select whether or notthe handset name is displayed in standbymode. The default setting is “No”. If you select“Yes” without entering any handset name,“Handset 1” to “Handset 6” is displayed.1 (middle soft key) #1042 Enter the desired name (max. 10characters; page 45).R If not required, go to step 3.34 MbN: Select the desired setting. a 2times5 M NIncoming call barring (Caller IDsubscribers only)This feature allows the unit to reject calls fromspecified phone numbers that you do not wantto answer such as junk calls.When a call is received, the unit does not ringwhile the caller is being identified. If the phonenumber matches an entry in the call barredlist, the unit sends out a busy tone to thecaller, and then disconnects the call.Important:R When the unit receives a call from anumber that is stored in the call barred list,the call is logged in the caller list(page 33) with after the call isdisconnected.Storing unwanted callersYou can store up to 30 phone numbers in thecall barred list.28ProgrammingTG80xxAL_NZ(en)_1021_ver001-2.pd28 28 2011/10/21 15:09:42