Panasonic KX-TG8032AL Operating Instructions Manual

Also see for KX-TG8032AL: Operating instructions

Changing the base unit PIN(Personal Identification Number)Important:R If you change the PIN, please make note ofyour new PIN. The unit will not reveal thePIN to you. If you forget your PIN, contactan authorised service centre.1 (middle soft key) #1322 Enter the current 4-digit base unit PIN(default: “0000”).3 Enter the new 4-digit base unit PIN. aa M NRegistering a unitOperating additional unitsAdditional handsetsUp to 6 handsets can be registered to thebase unit.Important:R The additional handset modelrecommended for use with this unit is notedon page 4. If another handset model isused, certain operations (handset settings,base unit settings, etc.) may not beavailable.Registering a handset to thebase unitThe supplied handset and base unit arepre-registered. If for some reason the handsetis not registered to the base unit (for example,is displayed even when the handset isnear the base unit), re-register the handset.1 Handset:(middle soft key) #1302 Base unit:Press and hold M N for about 5 seconds,until the registration tone sounds.R If all registered handsets start ringing,press M N again to stop, then repeatthis step.R The next step must be completedwithin 90 seconds.3 Handset:a Wait until “Base PIN” isdisplayed. a Enter the base unit PIN(default: “0000”). aR If you forget your PIN, contact anauthorised service centre.R When the handset has been registeredsuccessfully, is displayed.Note:R While registering, “Base inregistering” is displayed on allregistered handsets.R When you purchase an additional handset,refer to the additional handset’s installationmanual for registration.Deregistering a handsetA handset can cancel its own registration tothe base unit, or other handsets registered tothe same base unit. This allows the handset toend its wireless connection with the system.1 (middle soft key) #131R All handsets registered to the base unitare displayed.2 MbN: Select the handset you want tocancel. a3 MbN: “Yes” aR A confirmation tone sounds.R The handset does not beep whencancelling its own registration.4 M NOne touch eco modeIf you want to activate eco mode, set therepeater mode “Off” beforehand (page 44).The MECO/RN button on the handset enablesyou to activate the eco function with one touch.By activating eco mode, your unit can reducethe base unit transmission power by up to90% in standby mode.30ProgrammingTG80xxAL_NZ(en)_1021_ver001-2.pd30 30 2011/10/21 15:09:43