Note:R To switch to the receiver, press M N.R You can also use the MPLAYN soft key, ifdisplayed, to play new messages.Operating the answering systemMMENUN a MbN: “Answer device” aMSELECTNKey OperationMDN or MCN Adjust the receiver/speakervolume (during playback)1 or MFN Repeat message (duringplayback)*12 or MEN Skip message (duringplayback)3 Enter the “Settings” menu4 Play new messages5 Play all messages6 Play greeting message76 Record greeting message8 Turn answering system onMPAUSEN Pause message*29 orMSTOPNStop recordingStop playback0 Turn answering system off*4*3 Erase currently playingmessage*5 Erase all messages*6 Reset to a pre-recordedgreeting message*1 If pressed within the first 5 seconds of amessage, the previous message isplayed.*2 To resume playback:MbN: “Playback” a MSELECTN*3 You can also erase as follows:MPAUSEN a MbN: “Erase” aMSELECTN a MbN: “Yes” a MSELECTNCalling back (Caller ID subscribersonly)1 Press MPAUSEN during playback.2 MbN: “Call back” a MSELECTNEditing the number before calling back1 Press MPAUSEN during playback.2 MbN: “Edit & Call” a MSELECTN3 Press MEDITN repeatedly until the phonenumber is shown in the desired format(page 41). a M NErasing all messages1 MMENUN#3252 MbN: “Yes” a MSELECTN a MOFFNAdvanced new messagealerting featuresAudible message alertThis feature allows the base unit to beep toinform you of a new message arrival whennew messages are recorded. The base unitbeeps 2 times every minute until you listen tothe messages, if the “Base unit beep”setting is turned on. The default setting is“Off”.Handset1 MMENUN#3392 MbN: Select the desired setting. aMSAVEN a MOFFNNew message alert by a callThis feature allows you to receive anotification by phone when new messages arerecorded. The base unit calls a phone numberyou specify. You can then operate theanswering system remotely to listen to thenew message.To use this feature, you must:For assistance, please visit www.panasonic.com/support 45Answering SystemTGF34x_en_1201_ver043.pdf 45 2014/12/01 16:22:19