1.1.8 Phone User Interface ProgrammingYou can change the settings directly from the unit.For details about the operations, refer to the User Guide on the Panasonic Web site (® see Introduction).For details about additional features available with direct commands, see Section 2 Phone User InterfaceProgramming.1.1.8.1 Changing the Language for Phone User Interface ProgrammingYou can change the language used on the LCD. Because the language settings for the LCD of the base unitand handsets are not synchronized, you must set the languages individually for the base unit and each handset.The available languages may differ depending on the country/area of use.For details about changing the setting, refer to the User Guide on the Panasonic Web site (® seeIntroduction).1.1.9 Priority of Setting MethodsThe same settings can be configured by different configuration methods: provisioning, Web user interfaceprogramming, etc. This section explains which value is applied when the same setting is specified by multiplemethods.The following table shows the priority with which settings from each method are applied (lower numbers indicatehigher priority):Setting Order Priority Setting Method1 4 The factory default settings for the unit2 3 Pre-provisioning with the configuration file32–3 Provisioning with the master configuration file2–2 Provisioning with the product configuration file2–1 Provisioning with the standard configuration file4 1 Settings configured from the Web user interface or the phone userinterfaceAccording to the table, settings configured later override previous settings (i.e., settings listed lower in the tablehave a higher priority).If different values are specified for the same setting by the master configuration file and Web user interfaceprogramming, the value specified from the Web user interface is applied. This is because values specified fromthe Web user interface have a higher priority.For settings configured from the Web user interface and the phone user interface, the value specified mostrecently receives priority.1.1.10 Other Network Settings1.1.10.1 Firewall and Router SetupWhen the unit is connected to a network that is protected by a firewall and/or router, you need to configure thefirewall and/or router so that they do not block communication from the IP address and port number used bythe unit.30 Administrator Guide Document Version 2013-021.1.10 Other Network Settings
