4.3 KX-TDA Series Feature Programming for DPT Integration110 Installation Manual4.3.11 Voice Mail Transfer (VTR) Button AssignmentFor the Voice Mail Transfer feature to work at an extension, the extension must have the VTR button.This button must either be a DSS/BLF or CO button with a lamp. Follow the procedure below to assigna VTR button on an extension. (This is station level programming and should be done at eachindividual telephone.) PC programming is also available (see 4.3.12 Button Assignment via PCProgramming).1. Enter Personal Programming:While on-hook, press the PROGRAM button.(Display changes to PT-PGM Mode.)2. Press the desired Flexible (CO or DSS/BLF) button that you want to assign as the VTR button.3. Press [94].Screen output: VTR-4. Enter a Voice Mail floating extension number.Screen output: VTR- _ _ _(_ _ _ = The Voice Mail floating extension number you entered).5. Press the STORE button.6. Press the PROGRAM button or lift the handset to exit the Personal Programming mode.7. Repeat these steps for each telephone.4.3.12 Button Assignment via PC ProgrammingThe KX-TDA series users can assign buttons for Live Call Screening (LCS), Two-way Recording(TWR), Two-way Transfer (TWT), and Voice Mail Transfer (VTR) via PC Programming. Follow theprocedure below to assign each button.1. Go to "Extension-Wired Extension-Flexible Key" screen.Conditions: This button must be a flexible (CO or DSS/BLF)button to be programmed as a VTR button. When allVoice Mail ports are busy and this key is pressedfollowed by an extension number, the user will heareither a dial tone or a busy tone, depending on theCall Waiting on VM Group setting on the PBX.
