2.4 Installation OverviewInstallation Manual 412.4 Installation OverviewThe following is an overview of the steps needed to install optional cards and prepare the VPShardware for use. Once hardware installation is complete, see Customising the System forinstructions on software setup and VPS customisation.CAUTIONThe information below is only intended as an overview of the installation process. When installingthe VPS, refer to the sections listed below for detailed instructions.1. Open the covers (see 2.5 Opening/Closing the Covers).2. Remove the Dummy Cover Plates (see 2.6 Removing the Dummy Cover Plates).3. Install the optional cards (see 2.7 Installing Optional Cards—KX-TVM50 or 2.8 Installing OptionalCards—KX-TVM200).4. Connect the VPS to the appropriate extension ports of the PBX (see 1.2.2 ConnectionExamples—KX-TVM50 or 1.2.3 Connection Examples—KX-TVM200). Use 4-conductor or 2-conductor cable as necessary (see 2.9 PBX Connections).5. Connect the VPS to the PC to be used for programming (see 2.10 PC Connection).6. Connect the VPS to earth (see 2.11 Frame Earth Connection).7. Connect the AC adaptor to the VPS and to the power outlet (see 2.12 Connecting the ACAdaptor).CAUTIONThe power cord is the main disconnect device. Make sure that the power outlet is located nearthe VPS and is easily accessible.8. Secure the cables (see 2.13 Securing the Cables).9. Initialise the VPS (see 2.14 Initialising the VPS During Installation).10. Close the covers (see 2.5 Opening/Closing the Covers).11. Wall mount the VPS and AC adaptor (see 2.15 Wall Mounting).CAUTIONTo turn off the power on the VPS, first press the Shutdown button, wait for the AlarmIndicator to light, then turn off the power switch. Turning off the power switch before theAlarm Indicator lights may cause the VPS to take an exceptionally long time (up to 10minutes) to start up the next time the power is turned on.
