1. PressSetting orSetup .2. Press [ ] or [ ] to select "Information Display", and then press [ENTER].3. Press [ ] or [ ] to select "IP Address".4. Press [CANCEL].2. For authentication, enter your ID (username) and password, and then click OK.Notice• The default ID for the User account is "user", and the default password is blank. The ID cannot bechanged from the Web user interface, but it can be changed through configuration fileprogramming.• When you log in as User to the Web user interface for the first time, the [Change UserPassword] screen (® see 4.4.3 Change User Password) will be displayed. Enter a newpassword, and then perform authentication again with the new password to log in to the Web userinterface.• The default ID for the Administrator account is "admin", and the default password is "adminpass".The ID cannot be changed from the Web user interface, but it can be changed through configurationfile programming.3. The Web user interface window is displayed. Configure the settings for the unit as desired.4. You can log out from the Web user interface at any time by clicking [Web Port Close].Controls on the WindowThe Web user interface window contains various controls for navigating and configuring settings. The followingfigure shows the controls that are displayed on the [Basic Network Settings] screen as an example:ACDBNote• The screen shots shown are taken from the Web user interface of the KX-UT136 (or, in some cases,KX-UT248), so the model name may differ from that shown on your PC.• Actual default values may vary depending on your phone system dealer.• When you log in to the Web user interface with the User account, the languages of messages displayedon the configuration screen may differ depending on the country/area of use.24 Administrator Guide Document Version 2013-031.1.6 Web User Interface Programming
