Account Target User ID(default)Password(default) Password RestrictionsAdministrator Networkadministrators,etc.admin adminpass • When logged in as Administrator,you can change the password forboth the User and Administratoraccounts (® see4.5.2 AdministratorPassword).• The password can consist of 6 to16 ASCII characters(case-sensitive) (® seeEntering Characters in4.2.4 Accessing the Web UserInterface).Note• Only one account can be logged in to the Web user interface at a time. If you try to access the Webuser interface while someone is logged in, you will be denied access.• You cannot log in to the Web user interface even under the same account as someone who is alreadylogged in.• The user password is required to change the settings.• You can reset the account IDs and passwords to their factory default settings by performing Reset WebID/Password from the unit. For details, see 3.1.1.2 Reset Web ID/Password.4.2.4 Accessing the Web User InterfaceThe unit can be configured from the Web user interface.To access the Web user interface1. Open your Web browser, and then enter "http://" followed by the unit’s IP address into the address field ofyour browser.Note• To determine the unit’s IP address, perform the following operations on the unit:1. Press on the Home screen, and then tap [Settings].2. Tap [About phone] and then [Status].3. Confirm the IP address in [Network].2. For authentication, enter your ID (username) and password, and then click [OK].Notice• When you log in as User to the Web user interface for the first time, the [Change UserPassword] screen (® see 4.5.3 Change User Password) will be displayed. Enter a newpassword, and then perform authentication again with the new password to log in to the Web userinterface.Note• The default ID for the User account is "user", and the default password is blank. The ID cannot bechanged from the Web user interface, but it can be changed through configuration fileprogramming.Document Version 2012-07 Administrator Guide 63Section 4 Web User Interface Programming
