Value Format IntegerDescription Specifies the initial delay, in 10-millisecond units, of the jitter buffer.Value Range 1–7 (´ 10 ms)Note• This setting is subject to the following conditions:– This value must be greater than or equal to "MIN_DELAY"– This value must be less than "MAX_DELAY"Default Value 2 (´ 10 ms)Web User Interface Reference Initial Delay (Page 85)RTP_PORT_MINValue Format IntegerDescription Specifies the lowest port number that the unit will use for RTP packets.Note• If port numbers are specified in [Channel 1–25] in4.4.5.3 External RTP Port in the Web user interface, thissetting is ignored and the corresponding external RTP port isenabled.Value Range 1024–48750 (even number only)Note• The value for this setting must be less than or equal to"RTP_PORT_MAX" - 400.• Changing this setting may affect the number of simultaneouscalls that can be made. Therefore, when setting this parameter,be aware that the maximum number of necessary ports can becalculated as shown below:No. of lines ´ No. of channels ´ 2 ´ 10 (No. of terminals)Default Value 16000Web User Interface Reference Minimum RTP Port Number (Page 82)RTP_PORT_MAXValue Format IntegerDescription Specifies the highest port number that the unit will use for RTP packets.Note• If port numbers are specified in [Channel 1–25] in4.4.5.3 External RTP Port in the Web user interface, thissetting is ignored and the corresponding external RTP port isenabled.Document Version 2011-11 Administrator Guide 159Section 5 Configuration File Programming
