Answering a Video Conference CallDepending on your setting, you can either respond to a request to participate in a video conference callmanually (manual answer) or automatically (automatic answer) (Page 101).Note• Make sure that peripheral devices (e.g., display, main video camera) are turned on.• For sites operating as "Sub Sites" in multiple-party video conference calls using the Main Site’s built-inMCU, for each Sub Site, set "More than one incoming call" to "OFF" in "Call set up". With thissetting, calls cannot be received during a video conference call.When Manual Answer is SetWhen a video conference call is incoming there will be an incoming call ring, and a dialogue box is displayed.When the caller is registered in the contact list, the caller’s siteis displayed.When the caller is not registered, the caller’s IP address,connection number or other caller information that is receivedis displayed.Note• If the other party uses the same SIP domain name as you, only the SIP user name, and not the SIPURI (SIP user name@SIP domain name) is displayed.• If the caller’s group/site name, host name, SIP URI (or SIP user name), H.323 extension, or H.323name is too long to display, it will be shortened and ended with "...".Operation1 Press [START].• The video conference begins.• You can also answer the videoconference call by pressing [ENTER].156 User Manual Document Version 2015-03Starting a Video Conference
